linux/drivers/bluetooth, branch v4.6

Bluetooth: btmrvl_sdio: fix firmware activation failure

2016-03-10T18:51:29Z

In some case, the btmrvl_sdio firmware would fail to active within the polling time. Increase the polling interval to 100 msec to fix the issue. Signed-off-by: Wei-Ning Huang Signed-off-by: Wei-Ning Huang Signed-off-by: Marcel Holtmann

Bluetooth: btusb: Add a new AR3012 ID 13d3:3472

2016-03-10T18:51:28Z

T: Bus=01 Lev=01 Prnt=01 Port=04 Cnt=01 Dev#= 4 Spd=12 MxCh= 0 D: Ver= 1.10 Cls=e0(wlcon) Sub=01 Prot=01 MxPS=64 #Cfgs= 1 P: Vendor=13d3 ProdID=3472 Rev=00.01 C: #Ifs= 2 Cfg#= 1 Atr=e0 MxPwr=100mA I: If#= 0 Alt= 0 #EPs= 3 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb I: If#= 1 Alt= 0 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb BugLink: https://bugs.launchpad.net/bugs/1552925 Signed-off-by: Dmitry Tunin Signed-off-by: Marcel Holtmann Cc: stable@vger.kernel.org

Bluetooth: hci_bcm: Add BCM2E55 ACPI ID used in Lenovo ThinkPad Tablet 8

2016-03-10T18:51:28Z

Lenovo ThinkPad Tablet 8 with BCM43241 rev B5 chipset uses the BCM2E55 ACPI ID for Bluetooth. Add it to the list of supported devices. Signed-off-by: Jérôme de Bretagne Signed-off-by: Marcel Holtmann

Bluetooth: hci_uart: Add diag and address support for Intel/AG6xx

2016-02-29T17:25:22Z

The AG6xx devices behave similar to Wilkens Peak and Stone Peak and with that it is needed to check for Intel default address. In addition it is possible to enable vendor events and diag support. Signed-off-by: Marcel Holtmann Signed-off-by: Johan Hedberg

Bluetooth: btusb: Add a new AR3012 ID 04ca:3014

2016-02-28T19:25:20Z

T: Bus=01 Lev=01 Prnt=01 Port=04 Cnt=03 Dev#= 5 Spd=12 MxCh= 0 D: Ver= 1.10 Cls=e0(wlcon) Sub=01 Prot=01 MxPS=64 #Cfgs= 1 P: Vendor=04ca ProdID=3014 Rev=00.02 C: #Ifs= 2 Cfg#= 1 Atr=e0 MxPwr=100mA I: If#= 0 Alt= 0 #EPs= 3 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb I: If#= 1 Alt= 0 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb BugLink: https://bugs.launchpad.net/bugs/1546694 Signed-off-by: Dmitry Tunin Signed-off-by: Marcel Holtmann Cc: stable@vger.kernel.org

Bluetooth: hci_uart: Add Intel/AG6xx support

2016-02-24T15:34:23Z

This driver implements support for iBT2.1 Bluetooth controller embedded in the AG620 communication combo. The controller needs to be configured with bddata and can be patched with a binary patch file (pbn). These operations are performed in manufacturing mode. Signed-off-by: Loic Poulain Signed-off-by: Marcel Holtmann

Bluetooth: Add new AR3012 ID 0489:e095

2016-02-23T19:29:38Z

T: Bus=01 Lev=01 Prnt=01 Port=04 Cnt=02 Dev#= 3 Spd=12 MxCh= 0 D: Ver= 1.10 Cls=e0(wlcon) Sub=01 Prot=01 MxPS=64 #Cfgs= 1 P: Vendor=0489 ProdID=e095 Rev=00.01 C: #Ifs= 2 Cfg#= 1 Atr=e0 MxPwr=100mA I: If#= 0 Alt= 0 #EPs= 3 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb I: If#= 1 Alt= 0 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb This device requires ar3k/AthrBT_0x31010100.dfu and ar3k/ramps_0x31010100_40.dfu firmware files that are not in linux-firmware yet. BugLink: https://bugs.launchpad.net/bugs/1542944 Signed-off-by: Dmitry Tunin Signed-off-by: Marcel Holtmann Cc: stable@vger.kernel.org

Bluetooth: btbcm: Fix handling of firmware not found

2016-02-23T19:29:37Z

If the call to request_firmware() fails in btbcm_setup_patchram(), the BCM chip will be operating with its default firmware. In this case, btbcm_setup_patchram() should not return immediately but instead should skip to btbcm_check_bdaddr() and quirk setup. Signed-off-by: Petri Gynther Signed-off-by: Marcel Holtmann

Bluetooth: hci_bcm: Add BCM2E7C ACPI ID

2016-02-23T19:29:37Z

Recent macbooks (early 2015) with BCM43241 use this ACPI ID. Add it to the list of supported devices. Reported-by: Leif Liddy Signed-off-by: Mika Westerberg Signed-off-by: Marcel Holtmann

Bluetooth: hci_bcm: Add new ACPI ID for bcm43241

2016-02-23T19:29:37Z

This ACPI ID is used at least by HP for their Omni 10 5600eg tablet. Signed-off-by: J.J. Meijer Signed-off-by: Marcel Holtmann