linux/drivers/bus, branch v5.4

bus: ti-sysc: Fix watchdog quirk handling

2019-10-18T15:45:32Z

I noticed that when probed with ti-sysc, watchdog can trigger on am3, am4 and dra7 causing a device reset. Turns out I made several mistakes implementing the watchdog quirk handling: 1. We must do both writes to spr register 2. We must also call the reset quirk on disable 3. On am3 and am4 we need to also set swsup quirk flag I probably only tested this earlier with watchdog service running when the watchdog never gets disabled. Fixes: 4e23be473e30 ("bus: ti-sysc: Add support for module specific reset quirks") Signed-off-by: Tony Lindgren

Merge tag 'armsoc-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2019-09-30T17:04:28Z

Pull ARM SoC fixes from Olof Johansson: "A few fixes that have trickled in through the merge window: - Video fixes for OMAP due to panel-dpi driver removal - Clock fixes for OMAP that broke no-idle quirks + nfsroot on DRA7 - Fixing arch version on ASpeed ast2500 - Two fixes for reset handling on ARM SCMI" * tag 'armsoc-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: ARM: aspeed: ast2500 is ARMv6K reset: reset-scmi: add missing handle initialisation firmware: arm_scmi: reset: fix reset_state assignment in scmi_domain_reset bus: ti-sysc: Remove unpaired sysc_clkdm_deny_idle() ARM: dts: logicpd-som-lv: Fix i2c2 and i2c3 Pin mux ARM: dts: am3517-evm: Fix missing video ARM: dts: logicpd-torpedo-baseboard: Fix missing video ARM: omap2plus_defconfig: Fix missing video bus: ti-sysc: Fix handling of invalid clocks bus: ti-sysc: Fix clock handling for no-idle quirks

Merge tag 'fixes-5.4-merge-window' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap into arm/fixes

2019-09-29T18:20:48Z

Fixes for omap variants Few fixes for ti-sysc interconnect target module driver for no-idle quirks that caused nfsroot to fail on some dra7 boards. And let's fixes to get LCD working again for logicpd board that got broken a while back with removal of panel-dpi driver. We need to now use generic CONFIG_DRM_PANEL_SIMPLE instead. * tag 'fixes-5.4-merge-window' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap: bus: ti-sysc: Remove unpaired sysc_clkdm_deny_idle() ARM: dts: logicpd-som-lv: Fix i2c2 and i2c3 Pin mux ARM: dts: am3517-evm: Fix missing video ARM: dts: logicpd-torpedo-baseboard: Fix missing video ARM: omap2plus_defconfig: Fix missing video bus: ti-sysc: Fix handling of invalid clocks bus: ti-sysc: Fix clock handling for no-idle quirks Link: https://lore.kernel.org/r/pull-1568819401-72461@atomide.com Signed-off-by: Olof Johansson

Merge tag 'armsoc-late' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2019-09-20T22:53:02Z

Pull ARM SoC late updates from Arnd Bergmann: "This is some material that we picked up into our tree late or that had complex inter-depondencies. The fact that there are these interdependencies tends to meant that these are often actually the most interesting new additions: - The new Aspeed AST2600 baseboard management controller is added, this is a Cortex-A7 based follow-up to the ARM11 based AST2500 and had some dependencies on other device drivers. - After many years, support for the MMP2 based OLPC XO-1.75 finally makes it into the kernel. - The Armada 3720 based Turris Mox open source router platform is a late addition and it follows some preparatory work across multiple branches. - The OMAP2+ platform had some large-scale cleanup involving driver changes and DT changes, here we finish it off, dropping a lot of the now-unused platform data. - The TI K3 platform that got added for 5.3 gains a lot more support for individual bits on the SoC, this part just came late for the merge window" [ This pull request itself wasn't actually sent late at all by Arnd, but I waited on the branches that it used to be pulled first, so it ends up being merged much later than the other ARM SoC pull requests this merge window - Linus ] * tag 'armsoc-late' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (57 commits) ARM: dts: dir685: Drop spi-cpol from the display ARM: dts: aspeed: Add AST2600 pinmux nodes ARM: dts: aspeed: Add AST2600 and EVB ARM: exynos: Enable support for ARM architected timers ARM: samsung: Fix system restart on S3C6410 ARM: dts: mmp2: add OLPC XO 1.75 machine ARM: dts: mmp2: rename the USB PHY node ARM: dts: mmp2: specify reg-shift for the UARTs ARM: dts: mmp2: add camera interfaces ARM: dts: mmp2: fix the SPI nodes ARM: dts: mmp2: trivial whitespace fix arm64: dts: marvell: add DTS for Turris Mox dt-bindings: marvell: document Turris Mox compatible arm64: dts: marvell: armada-37xx: add SPI CS1 pinctrl arm64: dts: ti: k3-j721e-main: Fix gic-its node unit-address arm64: dts: ti: k3-am65-main: Fix gic-its node unit-address arm64: dts: ti: k3-j721e-main: Add hwspinlock node arm64: dts: ti: k3-am65-main: Add hwspinlock node arm64: dts: k3-j721e: Add gpio-keys on common processor board dt-bindings: pinctrl: k3: Introduce pinmux definitions for J721E ...

Merge tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2019-09-16T22:52:38Z

Pull ARM SoC driver updates from Arnd Bergmann: "This contains driver changes that are tightly connected to SoC specific code. Aside from smaller cleanups and bug fixes, here is a list of the notable changes. New device drivers: - The Turris Mox router has a new "moxtet" bus driver for its on-board pluggable extension bus. The same platform also gains a firmware driver. - The Samsung Exynos family gains a new Chipid driver exporting using the soc device sysfs interface - A similar socinfo driver for Qualcomm Snapdragon chips. - A firmware driver for the NXP i.MX DSP IPC protocol using shared memory and a mailbox Other changes: - The i.MX reset controller driver now supports the NXP i.MX8MM chip - Amlogic SoC specific drivers gain support for the S905X3 and A311D chips - A rework of the TI Davinci framebuffer driver to allow important cleanups in the platform code - A couple of device drivers for removed ARM SoC platforms are removed. Most of the removals were picked up by other maintainers, this contains whatever was left" * tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (123 commits) bus: uniphier-system-bus: use devm_platform_ioremap_resource() soc: ti: ti_sci_pm_domains: Add support for exclusive and shared access dt-bindings: ti_sci_pm_domains: Add support for exclusive and shared access firmware: ti_sci: Allow for device shared and exclusive requests bus: imx-weim: remove incorrect __init annotations fbdev: remove w90x900/nuc900 platform drivers spi: remove w90x900 driver net: remove w90p910-ether driver net: remove ks8695 driver firmware: turris-mox-rwtm: Add sysfs documentation firmware: Add Turris Mox rWTM firmware driver dt-bindings: firmware: Document cznic,turris-mox-rwtm binding bus: moxtet: fix unsigned comparison to less than zero bus: moxtet: remove set but not used variable 'dummy' ARM: scoop: Use the right include dt-bindings: power: add Amlogic Everything-Else power domains bindings soc: amlogic: Add support for Everything-Else power domains controller fbdev: da8xx: use resource management for dma fbdev: da8xx-fb: drop a redundant if fbdev: da8xx-fb: use devm_platform_ioremap_resource() ...

bus: ti-sysc: Remove unpaired sysc_clkdm_deny_idle()

2019-09-06T19:57:46Z

Commit d098913a10f8 ("bus: ti-sysc: Fix clock handling for no-idle quirks") fixed handling for no-idle quirk modules that are not enabled by the bootloader. But it also caused unpaired clockdomain calls that won't allow idling the system. That's because clkdm_allow_idle_nolock() and clkdm_deny_idle_nolock() have usage count with clkdm->forcewake_count. Let's drop the unpaired sysc_clkdm_deny_idle() to fix idling of devices. Fixes: d098913a10f8 ("bus: ti-sysc: Fix clock handling for no-idle quirks") Cc: Keerthy Cc: Vignesh Raghavendra Signed-off-by: Tony Lindgren

bus: ti-sysc: Fix handling of invalid clocks

2019-09-05T20:01:29Z

We can currently get "Unable to handle kernel paging request at virtual address" for invalid clocks with dts node but no driver: (__clk_get_hw) from [] (ti_sysc_find_one_clockdomain+0x18/0x34) (ti_sysc_find_one_clockdomain) from [] (ti_sysc_clkdm_init+0x34/0xdc) (ti_sysc_clkdm_init) from [] (sysc_probe+0xa50/0x10e8) (sysc_probe) from [] (platform_drv_probe+0x58/0xa8) Let's add IS_ERR checks to ti_sysc_clkdm_init() as And let's start treating clk_get() with -ENOENT as a proper error. If the clock name is specified in device tree we must succeed with clk_get() to continue. For modules with no clock names specified in device tree we will just ignore the clocks. Fixes: 2b2f7def058a ("bus: ti-sysc: Add support for missing clockdomain handling") Acked-by: Roger Quadros Tested-by: Keerthy Signed-off-by: Tony Lindgren

bus: uniphier-system-bus: use devm_platform_ioremap_resource()

2019-09-05T15:57:18Z

Replace the chain of platform_get_resource() and devm_ioremap_resource() with devm_platform_ioremap_resource(). This allows to remove the local variable for (struct resource *), and have one function call less. Link: https://lore.kernel.org/r/20190905032122.26076-1-yamada.masahiro@socionext.com Signed-off-by: Masahiro Yamada Signed-off-by: Arnd Bergmann

bus: ti-sysc: Fix clock handling for no-idle quirks

2019-09-05T14:37:22Z

NFSroot can fail on dra7 when cpsw is probed using ti-sysc interconnect target module driver as reported by Keerthy. Device clocks and the interconnect target module may or may not be enabled by the bootloader on init, but we currently assume the clocks and module are on from the bootloader for "ti,no-idle" and "ti,no-idle-on-init" quirks as reported by Grygorii Strashko. Let's fix the issue by always enabling clocks init, and never disable them for "ti,no-idle" quirk. For "ti,no-idle-on-init" quirk, we must decrement the usage count later on to allow PM runtime to idle the module if requested. Fixes: 1a5cd7c23cc5 ("bus: ti-sysc: Enable all clocks directly during init to read revision") Cc: Keerthy Cc: Vignesh Raghavendra Reported-by: Keerthy Reported-by: Grygorii Strashko Reviewed-by: Grygorii Strashko Signed-off-by: Tony Lindgren

bus: imx-weim: remove incorrect __init annotations

2019-09-04T15:59:32Z

The probe function is no longer __init, so anything it calls now must also be available at runtime, as Kbuild points out when building with clang-9: WARNING: vmlinux.o(.text+0x6e7040): Section mismatch in reference from the function weim_probe() to the function .init.text:imx_weim_gpr_setup() The function weim_probe() references the function __init imx_weim_gpr_setup(). This is often because weim_probe lacks a __init annotation or the annotation of imx_weim_gpr_setup is wrong. WARNING: vmlinux.o(.text+0x6e70f0): Section mismatch in reference from the function weim_probe() to the function .init.text:weim_timing_setup() The function weim_probe() references the function __init weim_timing_setup(). This is often because weim_probe lacks a __init annotation or the annotation of weim_timing_setup is wrong. Remove the remaining __init markings that are now wrong. Fixes: 4a92f07816ba ("bus: imx-weim: use module_platform_driver()") Signed-off-by: Arnd Bergmann