linux/drivers/counter, branch v6.4

Merge tag 'mfd-next-6.4' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd

2023-05-02T17:41:31Z

Pull MFD updates from Lee Jones: "New Drivers: - Add support for Renesas RZ/G2L MTU3 New Device Support: - Add support for Lenovo Yoga Book X90F to Intel CHT WC - Add support for MAX5970 and MAX5978 to Simple MFD (I2C) - Add support for Meteor Lake PCH-S LPSS PCI to Intel LPSS PCI - Add support for AXP15060 PMIC to X-Powers PMIC collection Remove Device Support: - Remove support for Samsung 5M8751 and S5M8763 PMIC devices New Functionality: - Convert deprecated QCOM IRQ Chip to config registers - Add support for 32-bit address spaces to Renesas SMUs Fix-ups: - Make use of APIs / MACROs designed to simplify and demystify - Add / improve Device Tree bindings - Memory saving struct layout optimisations - Remove old / deprecated functionality - Factor out unassigned register addresses from ranges - Trivial: Spelling fixes, renames and coding style fixes - Rid 'defined but not used' warnings - Remove ineffective casts and pointer stubs Bug Fixes: - Fix incorrectly non-inverted mask/unmask IRQs on QCOM platforms - Remove MODULE_*() helpers from non-tristate drivers - Do not attempt to use out-of-range memory addresses associated with io_base - Provide missing export helpers - Fix remap bulk read optimisation fallout - Fix memory leak issues in error paths" * tag 'mfd-next-6.4' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd: (88 commits) dt-bindings: mfd: ti,j721e-system-controller: Add SoC chip ID leds: bd2606mvv: Driver for the Rohm 6 Channel i2c LED driver dt-bindings: mfd: qcom,spmi-pmic: Document flash LED controller dt-bindings: mfd: x-powers,axp152: Document the AXP15060 variant mfd: axp20x: Add support for AXP15060 PMIC dt-bindings: mfd: x-powers,axp152: Document the AXP313a variant counter: rz-mtu3-cnt: Unlock on error in rz_mtu3_count_ceiling_write() dt-bindings: mfd: dlg,da9063: Document voltage monitoring dt-bindings: mfd: stm32: Remove unnecessary blank lines dt-bindings: mfd: qcom,spmi-pmic: Use generic ADC node name in examples dt-bindings: mfd: syscon: Add nuvoton,ma35d1-sys compatible MAINTAINERS: Add entries for Renesas RZ/G2L MTU3a counter driver counter: Add Renesas RZ/G2L MTU3a counter driver Documentation: ABI: sysfs-bus-counter: add cascade_counts_enable and external_input_phase_clock_select mfd: Add Renesas RZ/G2L MTU3a core driver dt-bindings: timer: Document RZ/G2L MTU3a bindings mfd: rsmu_i2c: Convert to i2c's .probe_new() again mfd: intel-lpss: Add Intel Meteor Lake PCH-S LPSS PCI IDs mfd: dln2: Fix memory leak in dln2_probe() mfd: axp20x: Fix axp288 writable-ranges ...

counter: rz-mtu3-cnt: Unlock on error in rz_mtu3_count_ceiling_write()

2023-04-26T10:40:35Z

These error paths need to call mutex_unlock(&priv->lock) before returning. The lock is taken in rz_mtu3_lock_if_counter_is_valid(). Fixes: 25d21447d896 ("counter: Add Renesas RZ/G2L MTU3a counter driver") Signed-off-by: Dan Carpenter Acked-by: William Breathitt Gray Signed-off-by: Lee Jones Link: https://lore.kernel.org/r/7b535d6b-6031-493a-84f6-82842089e637@kili.mountain

counter: Add Renesas RZ/G2L MTU3a counter driver

2023-04-26T10:40:35Z

Add RZ/G2L MTU3a counter driver. This IP supports the following phase counting modes on MTU1 and MTU2 channels 1) 16-bit phase counting modes on MTU1 and MTU2 channels. 2) 32-bit phase counting mode by cascading MTU1 and MTU2 channels. This patch adds 3 counter value channels. count0: 16-bit phase counter value channel on MTU1 count1: 16-bit phase counter value channel on MTU2 count2: 32-bit phase counter value channel by cascading MTU1 and MTU2 channels. The external input phase clock pin for the counter value channels are as follows: count0: "MTCLKA-MTCLKB" count1: "MTCLKA-MTCLKB" or "MTCLKC-MTCLKD" count2: "MTCLKA-MTCLKB" or "MTCLKC-MTCLKD" Use the sysfs variable "external_input_phase_clock_select" to select the external input phase clock pin and "cascade_counts_enable" to enable/ disable cascading of channels. Signed-off-by: Biju Das Reviewed-by: William Breathitt Gray Acked-by: William Breathitt Gray Signed-off-by: Lee Jones Link: https://lore.kernel.org/r/20230330111632.169434-5-biju.das.jz@bp.renesas.com

counter: 104-quad-8: Fix Synapse action reported for Index signals

2023-03-18T13:26:40Z

Signal 16 and higher represent the device's Index lines. The priv->preset_enable array holds the device configuration for these Index lines. The preset_enable configuration is active low on the device, so invert the conditional check in quad8_action_read() to properly handle the logical state of preset_enable. Fixes: f1d8a071d45b ("counter: 104-quad-8: Add Generic Counter interface support") Cc: Link: https://lore.kernel.org/r/20230316203426.224745-1-william.gray@linaro.org/ Signed-off-by: William Breathitt Gray

counter: 104-quad-8: Fix race condition between FLAG and CNTR reads

2023-03-18T13:26:40Z

The Counter (CNTR) register is 24 bits wide, but we can have an effective 25-bit count value by setting bit 24 to the XOR of the Borrow flag and Carry flag. The flags can be read from the FLAG register, but a race condition exists: the Borrow flag and Carry flag are instantaneous and could change by the time the count value is read from the CNTR register. Since the race condition could result in an incorrect 25-bit count value, remove support for 25-bit count values from this driver; hard-coded maximum count values are replaced by a LS7267_CNTR_MAX define for consistency and clarity. Fixes: 28e5d3bb0325 ("iio: 104-quad-8: Add IIO support for the ACCES 104-QUAD-8") Cc: # 6.1.x Cc: # 6.2.x Link: https://lore.kernel.org/r/20230312231554.134858-1-william.gray@linaro.org/ Signed-off-by: William Breathitt Gray

counter: fix dependency references for config MICROCHIP_TCB_CAPTURE

2023-01-18T14:59:58Z

Commit dfeef15e73ca ("counter: microchip-tcp-capture: Add appropriate arch deps for TCP driver") intends to add appropriate dependencies for the config MICROCHIP_TCB_CAPTURE. It however prefixes the intended configs with CONFIG, but in Kconfig files in contrast to source files, the configs are referenced to without prefixing them with CONFIG. Fix the dependency references due to this minor misconception. Fixes: dfeef15e73ca ("counter: microchip-tcp-capture: Add appropriate arch deps for TCP driver") Signed-off-by: Lukas Bulwahn Link: https://lore.kernel.org/r/20230118074659.5909-1-lukas.bulwahn@gmail.com/ Signed-off-by: William Breathitt Gray

counter: microchip-tcp-capture: Add appropriate arch deps for TCP driver

2023-01-13T20:05:56Z

Add the CONFIG_SOC_AT91SAM9 and CONFIG_SOC_SAM_V7 deps for the Microchip SoCs that support this IP block/driver plus compile time testing. Signed-off-by: Peter Robinson Link: https://lore.kernel.org/r/20230108074750.443705-4-pbrobinson@gmail.com/ Signed-off-by: William Breathitt Gray

counter: ftm-quaddec: Depend on the Layerscape SoC

2023-01-13T20:05:41Z

At the moment only the Freescale LS1021A is the only HW that supports this IP block so add an appropriate dependency and compile test. Signed-off-by: Peter Robinson Link: https://lore.kernel.org/r/20230108074750.443705-3-pbrobinson@gmail.com/ Signed-off-by: William Breathitt Gray

counter: intel-qep: Depend on X86

2023-01-13T20:05:23Z

Limit the Intel counter driver to X86, it doesn't make sense to build it for all arches if the counter subsystem is enabled. Signed-off-by: Peter Robinson Link: https://lore.kernel.org/r/20230108074750.443705-2-pbrobinson@gmail.com/ Signed-off-by: William Breathitt Gray

counter: Sort the Kconfig entries alphabetically

2023-01-13T20:04:20Z

Sort the Kconfig menu alphabetically to make it easier to read as the list grows larger. Signed-off-by: Peter Robinson Link: https://lore.kernel.org/r/20230108074750.443705-1-pbrobinson@gmail.com/ Signed-off-by: William Breathitt Gray