linux/drivers/gpu/host1x/debug.c, branch v4.20

gpu: host1x: Cleanup loop variable usage

2018-05-18T19:50:40Z

Use unsigned int where possible and don't unnecessarily initialize the loop variable. Reviewed-by: Dmitry Osipenko Tested-by: Dmitry Osipenko Signed-off-by: Thierry Reding

gpu: host1x: Improve debug disassembly formatting

2017-10-20T12:19:52Z

The host1x driver prints out "disassembly" dumps of the command FIFO and gather contents on submission timeouts. However, the output has been quite difficult to read with unnecessary newlines and occasional missing parentheses. Fix these problems by using pr_cont to remove unnecessary newlines and by fixing other small issues. Signed-off-by: Mikko Perttunen Reviewed-by: Dmitry Osipenko Tested-by: Dmitry Osipenko Signed-off-by: Thierry Reding

gpu: host1x: Refactor channel allocation code

2017-06-15T12:25:38Z

This is largely a rewrite of the Host1x channel allocation code, bringing several changes: - The previous code could deadlock due to an interaction between the 'reflock' mutex and CDMA timeout handling. This gets rid of the mutex. - Support for more than 32 channels, required for Tegra186 - General refactoring, including better encapsulation of channel ownership handling into channel.c Signed-off-by: Mikko Perttunen Reviewed-by: Dmitry Osipenko Tested-by: Dmitry Osipenko Signed-off-by: Thierry Reding

gpu: host1x: Whitespace cleanup for readability

2016-06-23T09:59:30Z

Insert a number of blank lines in places where they increase readability of the code. Also collapse various variable declarations to shorten some functions and finally rewrite some code for readability. Signed-off-by: Thierry Reding

gpu: host1x: Fix a couple of checkpatch warnings

2016-06-23T09:59:28Z

Fix a couple of occurrences where no blank line was used to separate variable declarations from code or where block comments were wrongly formatted. Signed-off-by: Thierry Reding

gpu: host1x: Consistently use unsigned int for counts

2016-06-23T09:59:23Z

The number of channels, syncpoints, bases and mlocks can never be negative, so use unsigned int instead of int. Also make loop variables the same type for consistency. Signed-off-by: Thierry Reding

gpu: host1x: Fix build warnings

2013-12-19T08:29:52Z

When debugfs support isn't enabled, gcc complains about some variables being unused. To avoid further #ifdefery, move debugfs specific setup code into static functions and use IS_ENABLED(CONFIG_DEBUG_FS) to have the compiler, rather than the preprocessor, discard them when unused. The advantage of doing it this way is that all the code will be compile-tested whether or not debugfs support is enabled. Signed-off-by: Thierry Reding

gpu: host1x: Add debug support

2013-04-22T10:32:46Z

Add support for host1x debugging. Adds debugfs entries, and dumps channel state to UART in case of stuck job. Signed-off-by: Arto Merilainen Signed-off-by: Terje Bergstrom Reviewed-by: Thierry Reding Tested-by: Thierry Reding Tested-by: Erik Faye-Lund Signed-off-by: Thierry Reding