linux/drivers/memory, branch v5.8

Merge branch 'baikal/drivers' into arm/drivers

2020-05-28T12:18:11Z

[arnd: This is a patch series from Serge Semin to add a few drivers that don't have any other subsystem maintainer tree to go through, so I'm picking them up through the soc tree, full series description from the mailing list below] Baikal-T1 SoC CPU is based on two MIPS Warrior P5600 cores. Their main memory Non-Coherent IO interface is connected to the OCP2AXI bridge, which in turn is then connected to the DW AMBA 3 AXI Interconnect (so called Main Interconnect) with nine masters and four slaves ports. Main Interconnect is responsible for the AXI-bus traffic arbitration (QoS) and its routing from one component to another. In addition there is a Errors Handler Block (EHB) accesible by means of the Baikal-T1 SoC System Controller responsible to detect AXI protocol errors and device not responding situations built on top the interconnect. Baikal-T1 AXI-bus driver included in this patchset will be responsible for working with that functionality, though currently it doesn't support QoS tuning. Instead it's capable of detecting the error events, reporting an info about them to the system log, injecting artificial errors to test the driver functionality. Since AXI Interconnect doesn't provide a way to find out which devices are connected to it, so its DT node is supposed to be compatible with "simple-bus" driver, while sub-nodes shall represent the masters attached to the bus. One of the AXI Interconnect slaves is an AXI-APB bridge used to access the Baikal-T1 SoC subsystems CSRs. MMIO request from CPU and DMAC masters are routed there if they are detected to be within [0x08000000 0x1FFFFFFF] range of the physical memory. In case if an attempted APB transaction stays with no response for a pre-defined time it will be detected by the APB-bus Errors Handler Block (EHB), which will raise an interrupt, then the bus gets freed for a next operation. The APB-bus driver provides the interrupt handler to detect the erroneous address, update an errors counter and prints an error message about the faulty address. The counter and the APB-bus operations timeout can be accessed via corresponding sysfs nodes. A dedicated sysfs-node can be also used to artificially cause the bus errors described above. Since APB-bus is a platform bus, it doesn't provide a way to detect slave devices connected to it, so similarly to the AXI-bus it's also supposed to be compatible with "simple-bus" driver. Aside from PCIe/SATA/DDR/I2C/EHB/CPU/reboot specific settings the Baikal-T1 System Controller provides a MIPS P5600 CM2 L2-cache tuning block. It is responsible for the setting up the Tag/Data/WS L2-to-RAM latencies. The last small patch in this patchset provides a driver and DT-schema-based binding for the described device. So that the latencies can be tuned up by means of dedicated DT properties and sysfs nodes. This patchset is rebased and tested on the mainline Linux kernel 5.7-rc4. Changelog v2 (AXI/APB bus): - Assign dual GPL/BSD licenses to the bindings. - Use single lined copyright headers in the bindings. - Replace "additionalProperties: false" property with "unevaluatedProperties: false" in the bindings. - Don't use a multi-arg clock phandle reference in DT binding examples. Thus remove includes from there. - Fix some commit message and Kconfig help text spelling. - Move drivers from soc to the bus subsystem. - Convert a simple EHB drivers to the Baikal-T1 AXI and APB bus ones. - Convert APB bus driver to using regmap MMIO API. - Use syscon regmap to access the AXI-bus erroneous address. - Add reset line support. - Add Main Interconnect clock support to the AXI-bus driver. - Remove probe-status info string printout. - Discard of_match_ptr() macro utilization. - Don't print error-message if no platform IRQ found. Just return an error. - Use generic FIELD_{GET,PREP} macros instead of handwritten ones in the AXI-bus driver. Changelog v2 (l2 driver): - Fix some commit message and Kconfig help text spelling. - Move the driver to the memory subsystem. - Assign dual GPL/BSD license to the DT binding. - Use single lined copyright header in the binding. - Discard reg property and syscon compatible string. - Move "allOf" restrictions to the root level of the properties. - The DT node is supposed to be a child of the Baikal-T1 system controller node. So regmap will be fetched from there. - Use generic FIELD_{GET,PREP} macro. - Remove probe-status info string printout. - Since the driver depends on the OF config we can remove of_match_ptr() macro utilization. Changelog v3: - Combine l2 and AXI/APB bus patches in a single patchset. - Retrieve AXI-bus QoS registers by resource name "qos". - Discard CONFIG_OF dependency since there is none at compile-time. - Add syscon EHB registers range to the AXI-bus reg property as optional entry. - Fix invalid of_property_read_u32() return value test in the l2-ctl driver. - Get the reg property back into the l2-ctl DT bindings even though the driver is using the parental syscon regmap. - The l2-ctl DT schema will live separately from the system controller, but the corresponding sub-node of the later DT schema will $ref this one. - Set non-default latencies in the l2-ctl DT example. * baikal/drivers: memory: Add Baikal-T1 L2-cache Control Block driver bus: Add Baikal-T1 APB-bus driver bus: Add Baikal-T1 AXI-bus driver dt-bindings: bus: Add Baikal-T1 APB-bus binding dt-bindings: bus: Add Baikal-T1 AXI-bus binding Link: https://lore.kernel.org/lkml/20200526130841.ap6qlxv7hqmabnh5@mobilestation/ Signed-off-by: Arnd Bergmann

memory: Add Baikal-T1 L2-cache Control Block driver

2020-05-28T12:17:41Z

Baikal-T1 SoC provides a way to tune the MIPS P5600 CM2 L2-cache performance up. It can be done by changing the L2-RAM Data/Tag/WS latencies in a dedicated register exposed by the system controller. The driver added by this commit provides a dts properties-based and sysfs-based interface for it. The device DT node is supposed to be a child of Baikal-T1 System Controller node. Link: https://lore.kernel.org/r/20200526125928.17096-7-Sergey.Semin@baikalelectronics.ru Signed-off-by: Serge Semin Cc: Alexey Malahov Cc: Paul Burton Cc: Olof Johansson Cc: Rob Herring Cc: linux-mips@vger.kernel.org Cc: soc@kernel.org Cc: devicetree@vger.kernel.org Signed-off-by: Arnd Bergmann

memory: samsung: exynos5422-dmc: Reduce protected code area in IRQ handler

2020-05-12T13:11:47Z

Speed-up a bit this IRQ processing as there is no need to protect return value or printing. Signed-off-by: Bernard Zhao Acked-by: Lukasz Luba Signed-off-by: Krzysztof Kozlowski

memory: samsung: exynos5422-dmc: Fix tFAW timings alignment

2020-05-08T14:46:41Z

Aligning of tFAW timing with standard was using wrong argument as minimum acceptable value. This could lead to wrong timing if provided timings and clock period do not match the standard. Fixes: 6e7674c3c6df ("memory: Add DMC driver for Exynos5422") Cc: Signed-off-by: Bernard Zhao Reviewed-by: Lukasz Luba Signed-off-by: Krzysztof Kozlowski

Merge tag 'arm-drivers-5.7' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2020-04-03T22:05:35Z

Pull ARM driver updates from Arnd Bergmann: "These are the usual updates for SoC specific device drivers and related subsystems that don't have their own top-level maintainers: - ARM SCMI/SCPI updates to allow pluggable transport layers - TEE subsystem cleanups - A new driver for the Amlogic secure power domain controller - Various driver updates for the NXP Layerscape DPAA2, NXP i.MX SCU and TI OMAP2+ sysc drivers. - Qualcomm SoC driver updates, including a new library module for "protection domain" notifications - Lots of smaller bugfixes and cleanups in other drivers" * tag 'arm-drivers-5.7' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (70 commits) soc: fsl: qe: fix sparse warnings for ucc_slow.c soc: fsl: qe: ucc_slow: remove 0 assignment for kzalloc'ed structure soc: fsl: qe: fix sparse warnings for ucc_fast.c soc: fsl: qe: fix sparse warnings for qe_ic.c soc: fsl: qe: fix sparse warnings for ucc.c soc: fsl: qe: fix sparse warning for qe_common.c soc: fsl: qe: fix sparse warnings for qe.c soc: qcom: Fix QCOM_APR dependencies soc: qcom: pdr: Avoid uninitialized use of found in pdr_indication_cb soc: imx: drop COMPILE_TEST for IMX_SCU_SOC firmware: imx: add COMPILE_TEST for IMX_SCU driver soc: imx: gpc: fix power up sequencing soc: imx: increase build coverage for imx8m soc driver soc: qcom: apr: Add avs/audio tracking functionality dt-bindings: soc: qcom: apr: Add protection domain bindings soc: qcom: Introduce Protection Domain Restart helpers devicetree: bindings: firmware: add ipq806x to qcom_scm memory: tegra: Correct debugfs clk rate-range on Tegra124 memory: tegra: Correct debugfs clk rate-range on Tegra30 memory: tegra: Correct debugfs clk rate-range on Tegra20 ...

.gitignore: add SPDX License Identifier

2020-03-25T10:50:48Z

Add SPDX License Identifier to all .gitignore files. Signed-off-by: Masahiro Yamada Signed-off-by: Greg Kroah-Hartman

memory: tegra: Correct debugfs clk rate-range on Tegra124

2020-03-11T14:24:16Z

Correctly set clk rate-range if number of available timings is zero. This fixes noisy "invalid range [4294967295, 0]" error messages during boot. Fixes: 6b9acd935546 ("memory: tegra: Refashion EMC debugfs interface on Tegra124") Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

memory: tegra: Correct debugfs clk rate-range on Tegra30

2020-03-11T14:24:16Z

Correctly set clk rate-range if number of available timings is zero. This fixes noisy "invalid range [4294967295, 0]" error messages during boot. Fixes: 8cee32b40040 ("memory: tegra: Implement EMC debugfs interface on Tegra30") Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

memory: tegra: Correct debugfs clk rate-range on Tegra20

2020-03-11T14:24:15Z

Correctly set clk rate-range if number of available timings is zero. This fixes noisy "invalid range [4294967295, 0]" error messages during boot. Fixes: 8209eefa3d37 ("memory: tegra: Implement EMC debugfs interface on Tegra20") Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

Merge tag 'mvebu-drivers-5.6-1' of git://git.infradead.org/linux-mvebu into arm/drivers

2020-01-16T18:45:44Z

mvebu drivers for 5.6 (part 1) - Various cleanup on the following drivers: - Turris Mox rWTM firmware - Moxtet bus - Armada 37xx rWTM mailbox - Marvell EBU Device Bus * tag 'mvebu-drivers-5.6-1' of git://git.infradead.org/linux-mvebu: mailbox: armada-37xx-rwtm: convert to devm_platform_ioremap_resource memory: mvebu-devbus: convert to devm_platform_ioremap_resource bus: moxtet: declare moxtet_bus_type as static firmware: turris-mox-rwtm: small white space cleanup Link: https://lore.kernel.org/r/877e1x3nxc.fsf@FE-laptop Signed-off-by: Olof Johansson