linux/drivers/nfc, branch v4.3

Merge tag 'gpio-v4.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio

2015-09-04T17:07:45Z

Pull GPIO updates from Linus Walleij: "This is the bulk of GPIO changes for the v4.3 kernel cycle. There is quite a lot going on in the GPIO subsystem this merge window, so the main matter is decribed below. The hits in other subsystems when making the GPIO flags optional are all ACKed by their respective subsystem maintainers. Core changes: - Root out the wrapper devm_gpiod_get() and gpiod_get() etc versions of the descriptor calls that did not use the flags argument on the end. This was around for too long and eventually Uwe Kleine-König took the time to clean it out and the last users are removed along with the macros in this tag. In several cases the use of flags simplifies the code. For this reason we have (ACKed) patches hitting in DRM, IIO, media, NFC, USB+PHY up until we hammer in the nail with removing the macros. - Add a fat document describing how much ready-made GPIO stuff we have i the kernel to discourage people from reinventing a square wheel in userspace, as so often happens. - Create a separate lockdep class for each instance of a GPIO IRQ chip instead of using one class for all chips, as the current code will not work with systems with several GPIO chips doing lockdep debugging. - Protect against driver unloading also when a GPIO line is only used as IRQ for the GPIOLIB_IRQCHIP helpers. - If the GPIO chip has no designated owner, assign the parent device driver owner as owner. - Consolidation of chained IRQ handler install/remove replacing all call sites where irq_set_handler_data() and irq_set_chained_handler() were done in succession with a combined call to irq_set_chained_handler_and_data(). This series was created by Thomas Gleixner after the problem was observed by Russell King. - Tglx also made another series of patches switching __irq_set_handler_locked() for irq_set_handler_locked() which is way cleaner. - Tglx and Jiang Liu wrote a good bunch of patches to make use of irq_desc_get_xxx() accessors and avoid looking up irq_descs from IRQ numbers. The goal is to get rid of the irq number from the handlers in the IRQ flow which is nice. - Rob Herring killed off the set_irq_flags() for all GPIO drivers. This was an ARM specific function that is replaced with the generic irq_modify_status() where special flags are actually needed. - When an OF node has a pin range for its GPIOs, return -EPROBE_DEFER if the pin controller isn't available. Pretty logical, yet needed to be fixed. - If a driver using GPIOLIB_IRQCHIP has its own irq_*_resources call back, then call these instead of the defaults provided by the GPIOLIB. - Fix an undocumented ABI hole: named GPIOs were not properly documented. Driver improvements: - Add get_direction() support to the generic GPIO driver, it's strange that we didn't have that before. - Make it possible to have input-only GPIO chips using the generic GPIO driver. - Clean out platform data support from the Emma Mobile (EM) driver - Finegrained runtime PM support for the RCAR driver. - Support r8a7795 (R-car H3) in the RCAR driver. - Support interrupts on GPIOs 16 thru 31 in the DaVinci driver. - Some consolidation and new support in the MPC8xxx driver, we now support MPC5125. - Preempt-RT-friendly patches: the OMAP, MPC8xxx, drivers uses raw spinlocks making it work better with the realime patches. - Interrupt support for the EXTRAXFS GPIO driver. - Make the ETRAXFS GPIO driver support also ARTPEC-3. - Interrupt and wakeup support for the BRCMSTB driver, also for wakeup from S5 cold boot. - Mask MXC IRQs during suspend. - Improve OMAP2 GPIO set_debounce() to work according to spec. - The VF610 driver handles IRQs properly. New drivers: - ZTE ZX GPIO driver" * tag 'gpio-v4.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio: (87 commits) Revert "gpio: extraxfs: fix returnvar.cocci warnings" gpio: tc3589x: use static container helper gpio: xlp: fix error return code gpio: vf610: handle level IRQ's properly gpio: max732x: Fix error handling in probe() gpio: omap: fix clk_prepare/unprepare usage gpio: omap: protect regs access in omap_gpio_irq_handler gpio: omap: fix omap2_set_gpio_debounce gpio: omap: switch to use platform_get_irq gpio: omap: remove wrong irq_domain_remove usage in probe gpiolib: add description for gpio irqchip fields in struct gpio_chip gpio: extraxfs: fix returnvar.cocci warnings gpiolib: irqchip: use different lockdep class for each gpio irqchip gpio/grgpio: fix deadlock in grgpio_irq_unmap() Documentation: gpio: consumer: describe active low property gpio: mxc: fix section mismatch warning gpio/mxc: mask gpio interrupts in suspend gpio: omap: Fix missing raw locks conversion gpio: brcmstb: support wakeup from S5 cold boot gpio: brcmstb: Add interrupt and wakeup source support ...

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next

2015-09-03T15:08:17Z

Pull networking updates from David Miller: "Another merge window, another set of networking changes. I've heard rumblings that the lightweight tunnels infrastructure has been voted networking change of the year. But what do I know? 1) Add conntrack support to openvswitch, from Joe Stringer. 2) Initial support for VRF (Virtual Routing and Forwarding), which allows the segmentation of routing paths without using multiple devices. There are some semantic kinks to work out still, but this is a reasonably strong foundation. From David Ahern. 3) Remove spinlock fro act_bpf fast path, from Alexei Starovoitov. 4) Ignore route nexthops with a link down state in ipv6, just like ipv4. From Andy Gospodarek. 5) Remove spinlock from fast path of act_gact and act_mirred, from Eric Dumazet. 6) Document the DSA layer, from Florian Fainelli. 7) Add netconsole support to bcmgenet, systemport, and DSA. Also from Florian Fainelli. 8) Add Mellanox Switch Driver and core infrastructure, from Jiri Pirko. 9) Add support for "light weight tunnels", which allow for encapsulation and decapsulation without bearing the overhead of a full blown netdevice. From Thomas Graf, Jiri Benc, and a cast of others. 10) Add Identifier Locator Addressing support for ipv6, from Tom Herbert. 11) Support fragmented SKBs in iwlwifi, from Johannes Berg. 12) Allow perf PMUs to be accessed from eBPF programs, from Kaixu Xia. 13) Add BQL support to 3c59x driver, from Loganaden Velvindron. 14) Stop using a zero TX queue length to mean that a device shouldn't have a qdisc attached, use an explicit flag instead. From Phil Sutter. 15) Use generic geneve netdevice infrastructure in openvswitch, from Pravin B Shelar. 16) Add infrastructure to avoid re-forwarding a packet in software that was already forwarded by a hardware switch. From Scott Feldman. 17) Allow AF_PACKET fanout function to be implemented in a bpf program, from Willem de Bruijn" * git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next: (1458 commits) netfilter: nf_conntrack: make nf_ct_zone_dflt built-in netfilter: nf_dup{4, 6}: fix build error when nf_conntrack disabled net: fec: clear receive interrupts before processing a packet ipv6: fix exthdrs offload registration in out_rt path xen-netback: add support for multicast control bgmac: Update fixed_phy_register() sock, diag: fix panic in sock_diag_put_filterinfo flow_dissector: Use 'const' where possible. flow_dissector: Fix function argument ordering dependency ixgbe: Resolve "initialized field overwritten" warnings ixgbe: Remove bimodal SR-IOV disabling ixgbe: Add support for reporting 2.5G link speed ixgbe: fix bounds checking in ixgbe_setup_tc for 82598 ixgbe: support for ethtool set_rxfh ixgbe: Avoid needless PHY access on copper phys ixgbe: cleanup to use cached mask value ixgbe: Remove second instance of lan_id variable ixgbe: use kzalloc for allocating one thing flow: Move __get_hash_from_flowi{4,6} into flow_dissector.c ixgbe: Remove unused PCI bus types ...

nfc: s3fwrn5: Add driver for Samsung S3FWRN5 NFC Chip

2015-08-20T19:23:39Z

Add driver for Samsung S3FWRN5 NFC controller. S3FWRN5 is using NCI protocol and I2C communication interface. Signed-off-by: Robert Baldyga Signed-off-by: Samuel Ortiz

NFC: trf7970a: Add NULL check to clear up smatch warning

2015-08-19T17:17:45Z

Although it should be unnecessary, add a NULL pointer check to trf7970a_send_upstream() to eliminate a smatch warning. Reported-by: Dan Carpenter Signed-off-by: Mark Greer Signed-off-by: Samuel Ortiz

NFC: trf7970a: SDD_EN is bit 5 not bit 3

2015-08-19T17:17:45Z

The SDD_EN bit in the NFC Target Detection Level Register is bit 5 not bit 3 so change the TRF7970A_NFC_TARGET_LEVEL_SDD_EN macro accordingly. Reported-by: Raymond Lei Signed-off-by: Mark Greer Signed-off-by: Samuel Ortiz

nfc: st-nci: Remove pr_err in rcv_queue when ndlc header is unknown

2015-08-16T23:27:23Z

spi phy needs to use ndlc_recv at every spi transaction causing "unknown packet control byte" error message each time the header is 00. Make this silent. Signed-off-by: Christophe Ricard Signed-off-by: Samuel Ortiz

nfc: st-nci: Add spi phy support for st21nfcb

2015-08-16T22:35:08Z

st21nfcb does support another phy than i2c: spi. st21nfcc does not support spi as the spi ios are used by the AMS RF booster. st21nfcb is not following NCI NFC Forum recommendations for spi but rely on ST prioritary protocol ndlc as for i2c. Signed-off-by: Christophe Ricard Signed-off-by: Samuel Ortiz

nfc: st-nci: Free data with irrelevant NDLC PCB_SYNC value

2015-08-16T22:35:08Z

PCB_SYNC different than PCB_TYPE_SUPERVISOR or PCB_TYPE_DATAFRAME should be discarded. Irrelevant data may be forwarded up to the ndlc state machine by phys like spi to prevent missing potential data during "write" transactions. Cc: stable@vger.kernel.org Signed-off-by: Christophe Ricard Signed-off-by: Samuel Ortiz

nfc: st-nci: Remove data from ack_pending_q when receiving a SYNC_ACK

2015-08-16T22:35:07Z

When receiving a NDLC PCB_SYNC_ACK the pending data was never removed from ack_pending_q and cleared. Cc: stable@vger.kernel.org Signed-off-by: Christophe Ricard Signed-off-by: Samuel Ortiz

NFC: st-nci: fix use of uninitialized variables in error path

2015-08-16T22:35:07Z

st_nci_hci_load_session() calls kfree_skb() on unitialized variables skb_pipe_info and skb_pipe_list if the call to nci_hci_connect_gate() failed. Reword the error path to not use these variables when they are not initialized. While at it, there seemed to be a memory leak because skb_pipe_info was only freed once, after the for-loop, even though several ones were created by nci_hci_send_cmd. Cc: stable@vger.kernel.org Acked-by: Christophe Ricard Signed-off-by: Nicolas Iooss Signed-off-by: Samuel Ortiz