linux/drivers/of, branch v5.6

drivers/of/of_mdio.c:fix of_mdiobus_register()

2020-03-04T03:01:51Z

When registers a phy_device successful, should terminate the loop or the phy_device would be registered in other addr. If there are multiple PHYs without reg properties, it will go wrong. Signed-off-by: Dajun Jin Reviewed-by: Andrew Lunn Signed-off-by: David S. Miller

Merge tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2020-02-08T22:04:19Z

Pull ARM SoC-related driver updates from Olof Johansson: "Various driver updates for platforms: - Nvidia: Fuse support for Tegra194, continued memory controller pieces for Tegra30 - NXP/FSL: Refactorings of QuickEngine drivers to support ARM/ARM64/PPC - NXP/FSL: i.MX8MP SoC driver pieces - TI Keystone: ring accelerator driver - Qualcomm: SCM driver cleanup/refactoring + support for new SoCs. - Xilinx ZynqMP: feature checking interface for firmware. Mailbox communication for power management - Overall support patch set for cpuidle on more complex hierarchies (PSCI-based) and misc cleanups, refactorings of Marvell, TI, other platforms" * tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (166 commits) drivers: soc: xilinx: Use mailbox IPI callback dt-bindings: power: reset: xilinx: Add bindings for ipi mailbox drivers: soc: ti: knav_qmss_queue: Pass lockdep expression to RCU lists MAINTAINERS: Add brcmstb PCIe controller entry soc/tegra: fuse: Unmap registers once they are not needed anymore soc/tegra: fuse: Correct straps' address for older Tegra124 device trees soc/tegra: fuse: Warn if straps are not ready soc/tegra: fuse: Cache values of straps and Chip ID registers memory: tegra30-emc: Correct error message for timed out auto calibration memory: tegra30-emc: Firm up hardware programming sequence memory: tegra30-emc: Firm up suspend/resume sequence soc/tegra: regulators: Do nothing if voltage is unchanged memory: tegra: Correct reset value of xusb_hostr soc/tegra: fuse: Add APB DMA dependency for Tegra20 bus: tegra-aconnect: Remove PM_CLK dependency dt-bindings: mediatek: add MT6765 power dt-bindings soc: mediatek: cmdq: delete not used define memory: tegra: Add support for the Tegra194 memory controller memory: tegra: Only include support for enabled SoCs memory: tegra: Support DVFS on Tegra186 and later ...

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2020-02-04T13:32:20Z

Pull networking fixes from David Miller: 1) Use after free in rxrpc_put_local(), from David Howells. 2) Fix 64-bit division error in mlxsw, from Nathan Chancellor. 3) Make sure we clear various bits of TCP state in response to tcp_disconnect(). From Eric Dumazet. 4) Fix netlink attribute policy in cls_rsvp, from Eric Dumazet. 5) txtimer must be deleted in stmmac suspend(), from Nicolin Chen. 6) Fix TC queue mapping in bnxt_en driver, from Michael Chan. 7) Various netdevsim fixes from Taehee Yoo (use of uninitialized data, snapshot panics, stack out of bounds, etc.) 8) cls_tcindex changes hash table size after allocating the table, fix from Cong Wang. 9) Fix regression in the enforcement of session ID uniqueness in l2tp. We only have to enforce uniqueness for IP based tunnels not UDP ones. From Ridge Kennedy. * git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (46 commits) gtp: use __GFP_NOWARN to avoid memalloc warning l2tp: Allow duplicate session creation with UDP r8152: Add MAC passthrough support to new device net_sched: fix an OOB access in cls_tcindex qed: Remove set but not used variable 'p_link' tc-testing: add missing 'nsPlugin' to basic.json tc-testing: fix eBPF tests failure on linux fresh clones net: hsr: fix possible NULL deref in hsr_handle_frame() netdevsim: remove unused sdev code netdevsim: use __GFP_NOWARN to avoid memalloc warning netdevsim: use IS_ERR instead of IS_ERR_OR_NULL for debugfs netdevsim: fix stack-out-of-bounds in nsim_dev_debugfs_init() netdevsim: fix panic in nsim_dev_take_snapshot_write() netdevsim: disable devlink reload when resources are being used netdevsim: fix using uninitialized resources bnxt_en: Fix TC queue mapping. bnxt_en: Fix logic that disables Bus Master during firmware reset. bnxt_en: Fix RDMA driver failure with SRIOV after firmware reset. bnxt_en: Refactor logic to re-enable SRIOV after firmware reset detected. net: stmmac: Delete txtimer in suspend() ...

treewide: remove redundant IS_ERR() before error code check

2020-02-04T03:05:27Z

'PTR_ERR(p) == -E*' is a stronger condition than IS_ERR(p). Hence, IS_ERR(p) is unneeded. The semantic patch that generates this commit is as follows: // @@ expression ptr; constant error_code; @@ -IS_ERR(ptr) && (PTR_ERR(ptr) == - error_code) +PTR_ERR(ptr) == - error_code // Link: http://lkml.kernel.org/r/20200106045833.1725-1-masahiroy@kernel.org Signed-off-by: Masahiro Yamada Cc: Julia Lawall Acked-by: Stephen Boyd [drivers/clk/clk.c] Acked-by: Bartosz Golaszewski [GPIO] Acked-by: Wolfram Sang [drivers/i2c] Acked-by: Rafael J. Wysocki [acpi/scan.c] Acked-by: Rob Herring Cc: Eric Biggers Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

net: mii_timestamper: fix static allocation by PHY driver

2020-01-31T15:46:11Z

If phydev->mii_ts is set by the PHY driver, it will always be overwritten in of_mdiobus_register_phy(). Fix it. Also make sure, that the unregister() doesn't do anything if the mii_timestamper was provided by the PHY driver. Fixes: 1dca22b18421 ("net: mdio: of: Register discovered MII time stampers.") Signed-off-by: Michael Walle Acked-by: Richard Cochran Signed-off-by: Jakub Kicinski

net: mdio: of: fix potential NULL pointer derefernce

2020-01-31T15:46:11Z

of_find_mii_timestamper() returns NULL if no timestamper is found. Therefore, guard the unregister_mii_timestamper() calls. Fixes: 1dca22b18421 ("net: mdio: of: Register discovered MII time stampers.") Signed-off-by: Michael Walle Acked-by: Richard Cochran Signed-off-by: Jakub Kicinski

Merge tag 'devicetree-for-5.6' of git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux

2020-01-30T15:47:58Z

Pull devicetree updates from Rob Herring: - Update dtc to upstream v1.5.1-22-gc40aeb60b47a (plus 1 revert) - Fix for DMA coherent devices on Power - Rework and simplify the DT phandle cache code - DT schema conversions for LEDS, gpio-leds, STM32 dfsdm, STM32 UART, STM32 ROMEM, STM32 watchdog, STM32 DMAs, STM32 mlahb, STM32 RTC, STM32 RCC, STM32 syscon, rs485, Renesas rCar CSI2, Faraday FTIDE010, DWC2, Arm idle-states, Allwinner legacy resets, PRCM and clocks, Allwinner H6 OPP, Allwinner AHCI, Allwinner MBUS, Allwinner A31 CSI, Allwinner h/w codec, Allwinner A10 system ctrl, Allwinner SRAM, Allwinner USB PHY, Renesas CEU, generic PCI host, Arm Versatile PCI - New binding schemas for SATA and PATA controllers, TI and Infineon VR controllers, MAX31730 - New compatible strings for i.MX8QM, WCN3991, renesas,r8a77961-wdt, renesas,etheravb-r8a77961 - Add USB 'super-speed-plus' as a documented speed - Vendor prefixes for broadmobi, calaosystems, kam, and mps - Clean-up the multiple flavors of ST-Ericsson vendor prefixes * tag 'devicetree-for-5.6' of git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux: (66 commits) scripts/dtc: Revert "yamltree: Ensure consistent bracketing of properties with phandles" of: Add OF_DMA_DEFAULT_COHERENT & select it on powerpc dt-bindings: leds: Convert gpio-leds to DT schema dt-bindings: leds: Convert common LED binding to schema dt-bindings: PCI: Convert generic host binding to DT schema dt-bindings: PCI: Convert Arm Versatile binding to DT schema dt-bindings: Be explicit about installing deps dt-bindings: stm32: convert dfsdm to json-schema dt-bindings: serial: Convert STM32 UART to json-schema dt-bindings: serial: Convert rs485 bindings to json-schema dt-bindings: timer: Use non-empty ranges in example dt-bindings: arm-boards: typo fix dt-bindings: Add TI and Infineon VR Controllers as trivial devices dt-binding: usb: add "super-speed-plus" dt-bindings: rcar-csi2: Convert bindings to json-schema dt-bindings: iio: adc: ad7606: Fix wrong maxItems value dt-bindings: Convert Faraday FTIDE010 to DT schema dt-bindings: Create DT bindings for PATA controllers dt-bindings: Create DT bindings for SATA controllers dt: bindings: add vendor prefix for Kamstrup A/S ...

of: Add OF_DMA_DEFAULT_COHERENT & select it on powerpc

2020-01-28T14:26:20Z

There's an OF helper called of_dma_is_coherent(), which checks if a device has a "dma-coherent" property to see if the device is coherent for DMA. But on some platforms devices are coherent by default, and on some platforms it's not possible to update existing device trees to add the "dma-coherent" property. So add a Kconfig symbol to allow arch code to tell of_dma_is_coherent() that devices are coherent by default, regardless of the presence of the property. Select that symbol on powerpc when NOT_COHERENT_CACHE is not set, ie. when the system has a coherent cache. Fixes: 92ea637edea3 ("of: introduce of_dma_is_coherent() helper") Cc: stable@vger.kernel.org # v3.16+ Reported-by: Christian Zigotzky Tested-by: Christian Zigotzky Signed-off-by: Michael Ellerman Reviewed-by: Ulf Hansson Signed-off-by: Rob Herring

of: overlay: Remove blank line between assignment and check

2020-01-08T16:49:23Z

There used to be blank lines between assignment and check of the __of_changeset_revert_entries() result, to make the phandle cache management operations stand out. After the removal of those operations in commit 90dc0d1ce890419f ("of: Rework and simplify phandle cache to use a fixed size"), there is no longer a reason to have such a blank line. Remove the blank line, to rejoin visibly the status assignement and check, and to match coding style. Signed-off-by: Geert Uytterhoeven Signed-off-by: Rob Herring

of: base: Add of_get_cpu_state_node() to get idle states for a CPU node

2020-01-02T15:50:04Z

The CPU's idle state nodes are currently parsed at the common cpuidle DT library, but also when initializing data for specific CPU idle operations, as in the PSCI cpuidle driver case and qcom-spm cpuidle case. To avoid open-coding, let's introduce of_get_cpu_state_node(), which takes the device node for the CPU and the index to the requested idle state node, as in-parameters. In case a corresponding idle state node is found, it returns the node with the refcount incremented for it, else it returns NULL. Moreover, for PSCI there are two options to describe the CPU's idle states [1], either via a flattened description or a hierarchical layout. Hence, let's take both options into account. [1] Documentation/devicetree/bindings/arm/psci.yaml Suggested-by: Sudeep Holla Co-developed-by: Lina Iyer Signed-off-by: Lina Iyer Reviewed-by: Rob Herring Reviewed-by: Daniel Lezcano Signed-off-by: Ulf Hansson Reviewed-by: Sudeep Holla