linux/drivers/phy/mediatek, branch v4.19

phy: phy-mtk-tphy: add property for BC12

2018-07-10T08:15:08Z

Some platforms support BC12 which is disabled by default, here add a property to enable it if need Signed-off-by: Chunfeng Yun Signed-off-by: Kishon Vijay Abraham I

phy: phy-mtk-tphy: add properties for eye diagram test

2018-07-10T08:15:08Z

Add properties for Eye diagram test of HQA which sometimes need adjust some parameters of u2phy Signed-off-by: Chunfeng Yun Signed-off-by: Kishon Vijay Abraham I

phy: phy-mtk-tphy: use SPDX license tag

2018-07-10T08:15:08Z

Use SPDX-License-Identifier tag instead of the GPL license text Signed-off-by: Chunfeng Yun Signed-off-by: Kishon Vijay Abraham I

phy: mediatek: add XS-PHY driver

2018-05-20T16:21:35Z

Support XS-PHY for MediaTek SoCs with USB3.1 GEN2 controller Signed-off-by: Chunfeng Yun Signed-off-by: Kishon Vijay Abraham I

phy: phy-mtk-tphy: add configurable parameters for slew rate calibrate

2018-03-16T08:10:42Z

There are two parameters, ref_clk and coefficient, for U2 slew rate calibrate which may vary on different SoCs, here allow them to be configurable Signed-off-by: Chunfeng Yun Reviewed-by: Matthias Brugger Signed-off-by: Kishon Vijay Abraham I

phy: phy-mtk-tphy: keep default value of mcu_bus_ck_gate_en

2018-03-16T08:10:42Z

The default value of mcu_bus_ck_gate_en is 1, if clear it, will prevent system to enter deep idle mode, so keep its default value and without affecting PCIe function. Signed-off-by: Chunfeng Yun Signed-off-by: Kishon Vijay Abraham I

phy: phy-mtk-tphy: use of_device_get_match_data()

2017-12-29T07:30:35Z

reduce the boilerplate code to get the specific data Signed-off-by: Chunfeng Yun Signed-off-by: Kishon Vijay Abraham I

phy: phy-mtk-tphy: make shared banks optional for V1 TPHY

2017-12-29T07:30:35Z

V1 TPHY for SATA doesn't have shared banks if it isn't shared with PCIe or USB, so make it optional. Signed-off-by: Chunfeng Yun Signed-off-by: Kishon Vijay Abraham I

phy: phy-mtk-tphy: use auto instead of force to bypass utmi signals

2017-12-29T07:30:35Z

When system is running, if usb2 phy is forced to bypass utmi signals, all PLL will be turned off, and it can't detect device connection anymore, so replace force mode with auto mode which can bypass utmi signals automatically if no device attached for normal flow. But keep the force mode to fix RX sensitivity degradation issue. Signed-off-by: Chunfeng Yun Signed-off-by: Kishon Vijay Abraham I

phy: phy-mtk-tphy: add set_mode callback

2017-10-23T05:49:25Z

This is used to force PHY with USB OTG function to enter a specific mode, and override OTG IDPIN(or IDDIG) signal. Signed-off-by: Chunfeng Yun Signed-off-by: Kishon Vijay Abraham I