linux/drivers/pinctrl, branch v4.7

pinctrl: baytrail: Fix mingled clock pins

2016-06-23T09:05:04Z

Fix plt clock 3, 4 and 5 pins, which were not in the proper order. Signed-off-by: Cristina Ciocan Acked-by: Mika Westerberg Signed-off-by: Linus Walleij

pinctrl: tegra: Fix build dependency

2016-06-22T15:58:07Z

I got below build error: ERROR: "tegra_xusb_padctl_legacy_probe" [drivers/phy/tegra/phy-tegra-xusb.ko] undefined! with below build configuration: CONFIG_ARCH_TEGRA=y CONFIG_PINCTRL_TEGRA_XUSB=y CONFIG_PHY_TEGRA_XUSB=y The problem is below line in drivers/pinctrl/Makefile obj-$(CONFIG_PINCTRL_TEGRA) += tegra/ So even CONFIG_PINCTRL_TEGRA_XUSB=y is set, kbuild still does not compile the code in drivers/pinctrl/tegra folder if !CONFIG_PINCTRL_TEGRA. phy-tegra-xusb.c does not use any symbol from pinctrl-tegra.c, so build pinctrl-tegra.c only when CONFIG_PINCTRL_TEGRA is set. Signed-off-by: Axel Lin Acked-by: Jon Hunter Signed-off-by: Linus Walleij

pinctrl: single: Fix missing flush of posted write for a wakeirq

2016-06-22T15:58:07Z

With many repeated suspend resume cycles, the pin specific wakeirq may not always work on omaps. This is because the write to enable the pin interrupt may not have reached the device over the interconnect before suspend happens. Let's fix the issue with a flush of posted write with a readback. Cc: stable@vger.kernel.org Reported-by: Nishanth Menon Signed-off-by: Tony Lindgren Signed-off-by: Linus Walleij

pinctrl: imx: Do not treat a PIN without MUX register as an error

2016-06-22T15:58:06Z

Some PINs do not have a MUX register, it is not an error. It is necessary to allow the continuation of the PINs configuration, otherwise the whole PIN-group will be configured incorrectly. Cc: stable@vger.kernel.org Signed-off-by: Alexander Shiyan Signed-off-by: Linus Walleij

pinctrl: mediatek: fix dual-edge code defect

2016-05-31T08:13:45Z

When a dual-edge irq is triggered, an incorrect irq will be reported on condition that the external signal is not stable and this incorrect irq has been registered. Correct the register offset. Cc: stable@vger.kernel.org Signed-off-by: Hongkun Cao Reviewed-by: Matthias Brugger Signed-off-by: Linus Walleij

pinctrl: nomadik: fix inversion of gpio direction

2016-05-30T07:42:37Z

The input/output directions were inversed on the GPIO direction read function. Loose a ! and it is correct. Signed-off-by: Linus Walleij

drivers/pinctrl/intel/pinctrl-baytrail.c: fix build with gcc-4.4

2016-05-26T22:35:44Z

gcc-4.4 and thereabouts has issues with initializers of anonymous unions, and it generates the following warnings: drivers/pinctrl/intel/pinctrl-baytrail.c:413: error: unknown field 'simple_funcs' specified in initializer drivers/pinctrl/intel/pinctrl-baytrail.c:413: warning: missing braces around initializer drivers/pinctrl/intel/pinctrl-baytrail.c:413: warning: (near initialization for 'byt_score_groups[0].') drivers/pinctrl/intel/pinctrl-baytrail.c:415: error: unknown field 'simple_funcs' specified in initializer drivers/pinctrl/intel/pinctrl-baytrail.c:417: error: unknown field 'simple_funcs' specified in initializer ... Work around this. Acked-by: Mika Westerberg Cc: Heikki Krogerus Cc: Linus Walleij Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

Merge tag 'pinctrl-v4.7-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

2016-05-19T19:50:56Z

Pull pin control updates from Linus Walleij: "This kernel cycle was quite calm when it comes to pin control and there is really just one major change, and that is the introduction of devm_pinctrl_register() managed resources. Apart from that linear development, details below. Core changes: - Add the devm_pinctrl_register() API and switch all applicable drivers to use it, saving lots of lines of code all over the place. New drivers: - driver for the Broadcom NS2 SoC - subdriver for the PXA25x SoCs - subdriver for the AMLogic Meson GXBB SoC Driver improvements: - the Intel Baytrail driver now properly supports pin control - Nomadik, Rockchip, Broadcom BCM2835 support the .get_direction() callback in the GPIO portions - continued development and stabilization of several SH-PFC SoC subdrivers: r8a7795, r8a7790, r8a7794 etc" * tag 'pinctrl-v4.7-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl: (85 commits) Revert "pinctrl: tegra: avoid parked_reg and parked_bank" pinctrl: meson: Fix eth_tx_en bit index pinctrl: tegra: avoid parked_reg and parked_bank pinctrl: tegra: Correctly check the supported configuration pinctrl: amlogic: Add support for Amlogic Meson GXBB SoC pinctrl: rockchip: fix pull setting error for rk3399 pinctrl: stm32: Implement .pin_config_dbg_show() pinctrl: nomadik: hide nmk_gpio_get_mode when unused pinctrl: ns2: rename pinctrl_utils_dt_free_map pinctrl: at91: Merge clk_prepare and clk_enable into clk_prepare_enable pinctrl: at91: Make at91_gpio_template const pinctrl: baytrail: fix some error handling in debugfs pinctrl: ns2: add pinmux driver support for Broadcom NS2 SoC pinctrl: sirf/atlas7: trivial fix of spelling mistake on flagged pinctrl: sh-pfc: Kill unused variable in sh_pfc_remove() pinctrl: nomadik: implement .get_direction() pinctrl: nomadik: use BIT() with offsets consequently pinctrl: exynos5440: Use off-stack memory for pinctrl_gpio_range pinctrl: zynq: Use devm_pinctrl_register() for pinctrl registration pinctrl: u300: Use devm_pinctrl_register() for pinctrl registration ...

Merge tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

2016-05-18T20:14:02Z

Pull ARM SoC driver updates from Arnd Bergmann: "Driver updates for ARM SoCs, these contain various things that touch the drivers/ directory but got merged through arm-soc for practical reasons. For the most part, this is now related to power management controllers, which have not yet been abstracted into a separate subsystem, and typically require some code in drivers/soc or arch/arm to control the power domains. Another large chunk here is a rework of the NVIDIA Tegra USB3.0 support, which was surprisingly tricky and took a long time to get done. Finally, reset controller handling as always gets merged through here as well" * tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (97 commits) arm-ccn: Enable building as module soc/tegra: pmc: Add generic PM domain support usb: xhci: tegra: Add Tegra210 support usb: xhci: Add NVIDIA Tegra XUSB controller driver dt-bindings: usb: xhci-tegra: Add Tegra210 XUSB controller support dt-bindings: usb: Add NVIDIA Tegra XUSB controller binding PCI: tegra: Support per-lane PHYs dt-bindings: pci: tegra: Update for per-lane PHYs phy: tegra: Add Tegra210 support phy: Add Tegra XUSB pad controller support dt-bindings: phy: tegra-xusb-padctl: Add Tegra210 support dt-bindings: phy: Add NVIDIA Tegra XUSB pad controller binding phy: core: Allow children node to be overridden clk: tegra: Add interface to enable hardware control of SATA/XUSB PLLs drivers: firmware: psci: make two helper functions inline soc: renesas: rcar-sysc: Add support for R-Car H3 power areas soc: renesas: rcar-sysc: Add support for R-Car E2 power areas soc: renesas: rcar-sysc: Add support for R-Car M2-N power areas soc: renesas: rcar-sysc: Add support for R-Car M2-W power areas soc: renesas: rcar-sysc: Add support for R-Car H2 power areas ...

Merge tag 'gpio-v4.7-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio

2016-05-18T00:39:42Z

Pull GPIO updates from Linus Walleij: "This is the bulk of GPIO changes for kernel cycle v4.7: Core infrastructural changes: - Support for natively single-ended GPIO driver stages. This means that if the hardware has registers to configure open drain or open source configuration, we use that rather than (as we did before) try to emulate it by switching the line to an input to get high impedance. This is also documented throughly in Documentation/gpio/driver.txt for those of you who did not understand one word of what I just wrote. - Start to do away with the unnecessarily complex and unitelligible ARCH_REQUIRE_GPIOLIB and ARCH_WANT_OPTIONAL_GPIOLIB, another evolutional artifact from the time when the GPIO subsystem was unmaintained. Archs can now just select GPIOLIB and be done with it, cleanups to arches will trickle in for the next kernel. Some minor archs ACKed the changes immediately so these are included in this pull request. - Advancing the use of the data pointer inside the GPIO device for storing driver data by switching the PowerPC, Super-H Unicore and a few other subarches or subsystem drivers in ALSA SoC, Input, serial, SSB, staging etc to use it. - The initialization now reads the input/output state of the GPIO lines, so that each GPIO descriptor knows - if this callback is implemented - whether the line is input or output. This also reflects nicely in userspace "lsgpio". - It is now possible to name GPIO producer names, line names, from the device tree. (Platform data has been supported for a while). I bet we will get a similar mechanism for ACPI one of those days. This makes is possible to get sensible producer names for e.g. GPIO rails in "lsgpio" in userspace. New drivers: - New driver for the Loongson1. - The XLP driver now supports Broadcom Vulcan ARM64. - The IT87 driver now supports IT8620 and IT8628. - The PCA953X driver now supports Galileo Gen2. Driver improvements: - MCP23S08 was switched to use the gpiolib irqchip helpers and now also suppors level-triggered interrupts. - 74x164 and RCAR now supports the .set_multiple() callback - AMDPT was converted to use generic GPIO. - TC3589x, TPS65218, SX150X, F7188X, MENZ127, VX855, WM831X, WM8994 support the new single ended callback for open drain and in some cases open source. - Implement the .get_direction() callback for a few more drivers like PL061, Xgene. Cleanups: - Paul Gortmaker combed through the drivers and de-modularized those who are not really modules. - Move the GPIO poweroff DT bindings to the power subdir where they belong. - Rename gpio-generic.c to gpio-mmio.c, which is much more to the point. That's what it is handling, nothing more, nothing less" * tag 'gpio-v4.7-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-gpio: (126 commits) MIPS: do away with ARCH_[WANT_OPTIONAL|REQUIRE]_GPIOLIB gpio: zevio: make it explicitly non-modular gpio: timberdale: make it explicitly non-modular gpio: stmpe: make it explicitly non-modular gpio: sodaville: make it explicitly non-modular pinctrl: sh-pfc: Let gpio_chip.to_irq() return zero on error gpio: dwapb: Add ACPI device ID for DWAPB GPIO controller on X-Gene platforms gpio: dt-bindings: add wd,mbl-gpio bindings gpio: of: make it possible to name GPIO lines gpio: make gpiod_to_irq() return negative for NO_IRQ gpio: xgene: implement .get_direction() gpio: xgene: Enable ACPI support for X-Gene GFC GPIO driver gpio: tegra: Implement gpio_get_direction callback gpio: set up initial state from .get_direction() gpio: rename gpio-generic.c into gpio-mmio.c gpio: generic: fix GPIO_GENERIC_PLATFORM is set to module case gpio: dwapb: add gpio-signaled acpi event support gpio: dwapb: convert device node to fwnode gpio: dwapb: remove name from dwapb_port_property gpio/qoriq: select IRQ_DOMAIN ...