linux/drivers/power, branch v3.8

Merge tag 'fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

2013-01-09T02:53:56Z

Pull ARM SoC fixes from Olof Johansson: "People are back from the holiday breaks, and it shows. Here are a bunch of fixes for a number of platforms: - A couple of small fixes for Nomadik - A larger set of changes for kirkwood/mvebu - uart driver selection, dt clocks, gpio-poweroff fixups, a few __init annotation fixes and some error handling improvement in their xor dma driver. - i.MX had a couple of minor fixes (and a critical one for flexcan2 clock setup) - MXS has a small board fix and a framebuffer bugfix - A set of fixes for Samsung Exynos, fixing default bootargs and some Exynos5440 clock issues - A set of OMAP changes including PM fixes and a few sparse warning fixups All in all a bit more positive code delta than we'd ideally want to see here, mostly from the OMAP PM changes, but nothing overly crazy." * tag 'fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (44 commits) ARM: clps711x: Fix bad merge of clockevents setup ARM: highbank: save and restore L2 cache and GIC on suspend ARM: highbank: add a power request clear ARM: highbank: fix secondary boot and hotplug ARM: highbank: fix typos with hignbank in power request functions ARM: dts: fix highbank cpu mpidr values ARM: dts: add device_type prop to cpu nodes on Calxeda platforms ARM: mx5: Fix MX53 flexcan2 clock ARM: OMAP2+: am33xx-hwmod: Fix wrongly terminated am33xx_usbss_mpu_irqs array pinctrl: mvebu: make pdma clock on dove mandatory ARM: Dove: Add pinctrl clock to DT dma: mv_xor: fix error handling for clocks dma: mv_xor: fix error handling of mv_xor_channel_add() arm: mvebu: Add missing ; for cpu node. arm: mvebu: Armada XP MV78230 has only three Ethernet interfaces arm: mvebu: Armada XP MV78230 has two cores, not one clk: mvebu: Remove inappropriate __init tagging ARM: Kirkwood: Use fixed-regulator instead of board gpio call ARM: Kirkwood: Fix missing sdio clock ARM: Kirkwood: Switch TWSI1 of 88f6282 to DT clock providers ...

Power: gpio-poweroff: Fix documentation and gpio_is_valid

2013-01-06T17:53:00Z

Improve the documentation to clarify level vs edge triggered power off. Improve the comments for level vs edge triggered power off. Make use of gpio_is_valid(). Reported-by: Stephen Warren Signed-off-by: Andrew Lunn Signed-off-by: Jason Cooper

Drivers: power: remove __dev* attributes.

2013-01-03T23:57:14Z

CONFIG_HOTPLUG is going away as an option. As a result, the __dev* markings need to be removed. This change removes the use of __devinit, __devexit_p, __devinitconst, and __devexit from these drivers. Based on patches originally written by Bill Pemberton, but redone by me in order to handle some of the coding style issues better, by hand. Cc: Bill Pemberton Cc: Anton Vorontsov Cc: David Woodhouse Cc: Andrew Lunn Cc: Jamie Lentin Cc: Jason Cooper Signed-off-by: Greg Kroah-Hartman

Merge tag 'omap-late-cleanups' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

2012-12-30T17:59:21Z

Pull late ARM cleanups for omap from Olof Johansson: "From Tony Lindgren: Here are few more patches to finish the omap changes for multiplatform conversion that are not strictly fixes, but were too complex to do with the dependencies during the merge window. Those are to move of serial-omap.h to platform_data, and the removal of remaining cpu_is_omap macro usage outside mach-omap2. Then there are several trivial fixes for typos and few minimal omap2plus_defconfig updates." * tag 'omap-late-cleanups' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: arch/arm/mach-omap2/dpll3xxx.c: drop if around WARN_ON OMAP2: Fix a typo - replace regist with register. ARM/omap: use module_platform_driver macro ARM: OMAP2+: PMU: Remove unused header ARM: OMAP4: remove duplicated include from omap_hwmod_44xx_data.c ARM: OMAP2+: omap2plus_defconfig: enable twl4030 SoC audio ARM: OMAP2+: omap2plus_defconfig: Add tps65217 support ARM: OMAP2+: enable devtmpfs and devtmpfs automount ARM: OMAP2+: omap_twl: Change TWL4030_MODULE_PM_RECEIVER to TWL_MODULE_PM_RECEIVER ARM: OMAP2+: Drop plat/cpu.h for omap2plus ARM: OMAP: Split fb.c to remove last remaining cpu_is_omap usage MAINTAINERS: Add an entry for omap related .dts files

Merge tag 'for-v3.8-part2' of git://git.infradead.org/battery-2.6

2012-12-19T16:14:08Z

Pull battery update, part 2, from Anton Vorontsov: "These are left overs that I didn't have time to review/apply before the merge window opened. I didn't want to "spoil" the first pull request with these late patches, so they were not included: - A small patch for the RX51 OMAP board (Nokia N900 phone), the patch creates a battery monitor device instance, so that it can be probed. It was acked by the OMAP maintainer; - A couple of late bug fixes for the charger-manager: corrects corner cases for the battery full handling." * tag 'for-v3.8-part2' of git://git.infradead.org/battery-2.6: charger-manager: Fix bug when check dropped voltage after fullbatt event charger-manager: Fix bug related to checking fully charged state of battery ARM: OMAP: rx51: Register platform device for rx51_battery

ARM: OMAP2+: Drop plat/cpu.h for omap2plus

2012-12-17T18:50:41Z

The cpu_is_omap macros are now local to arch/arm/mach-omap2 in soc.h and plat/cpu.h can finally be dropped for omap2+. Thanks everybody for help with fixing the drivers. Note that we can now also remove the unused plat/cpu.h from smartreflex.c and isp.c as they will cause compile errors with ARCH_MULTIPLATFORM enabled. Cc: Kevin Hilman Acked-by: Jean Pihet Acked-by: Laurent Pinchart Acked-by: Mauro Carvalho Chehab Signed-off-by: Tony Lindgren

charger-manager: Fix bug when check dropped voltage after fullbatt event

2012-12-17T06:45:58Z

This patch check difference value between current voltage of battery and desc->fullbatt_uV whether positve or negative number. If difference value is negative number when current voltage of battery is larger than desc->fullbatt_uV, charger-manager return immediately because battery is fully charged. Signed-off-by: Chanwoo Choi Signed-off-by: Myungjoo Ham Signed-off-by: Kyungmin Park Signed-off-by: Anton Vorontsov

charger-manager: Fix bug related to checking fully charged state of battery

2012-12-17T06:43:23Z

This patch fix bug related to checking fully charged state of battery when charger-manager call is_full_charged() function. After reading property of charger/fuel-gauge through power_supply API, val.intval is more than 1. So, is_full_charged() function always return true. If true, battery means fully charged state. Signed-off-by: Chanwoo Choi Signed-off-by: Myungjoo Ham Signed-off-by: Kyungmin Park Signed-off-by: Anton Vorontsov

Merge tag 'mfd-3.8-1' of git://git.kernel.org/pub/scm/linux/kernel/git/sameo/mfd-2.6

2012-12-17T02:55:20Z

Pull MFS update from Samuel Ortiz: "This is the MFD patch set for the 3.8 merge window. We have several new drivers, most of the time coming with their sub devices drivers: - Austria Microsystem's AS3711 - Nano River's viperboard - TI's TPS80031, AM335x TS/ADC, - Realtek's MMC/memstick card reader - Nokia's retu We also got some notable cleanups and improvements: - tps6586x got converted to IRQ domains. - tps65910 and tps65090 moved to the regmap IRQ API. - STMPE is now Device Tree aware. - A general twl6040 and twl-core cleanup, with moves to the regmap I/O and IRQ APIs and a conversion to the recently added PWM framework. - sta2x11 gained regmap support. Then the rest is mostly tiny cleanups and fixes, among which we have Mark's wm5xxx and wm8xxx patchset." Far amount of annoying but largely trivial conflicts. Many due to __devinit/exit removal, others due to one or two of the new drivers also having come in through another tree. * tag 'mfd-3.8-1' of git://git.kernel.org/pub/scm/linux/kernel/git/sameo/mfd-2.6: (119 commits) mfd: tps6507x: Convert to devm_kzalloc mfd: stmpe: Update DT support for stmpe driver mfd: wm5102: Add readback of DSP status 3 register mfd: arizona: Log if we fail to create the primary IRQ domain mfd: tps80031: MFD_TPS80031 needs to select REGMAP_IRQ mfd: tps80031: Add terminating entry for tps80031_id_table mfd: sta2x11: Fix potential NULL pointer dereference in __sta2x11_mfd_mask() mfd: wm5102: Add tuning for revision B mfd: arizona: Defer patch initialistation until after first device boot mfd: tps65910: Fix wrong ack_base register mfd: tps65910: Remove unused data mfd: stmpe: Get rid of irq_invert_polarity mfd: ab8500-core: Fix invalid free of devm_ allocated data mfd: wm5102: Mark DSP memory regions as volatile mfd: wm5102: Correct default for LDO1_CONTROL_2 mfd: arizona: Register haptics devices mfd: wm8994: Make current device behaviour the default mfd: tps65090: MFD_TPS65090 needs to select REGMAP_IRQ mfd: Fix stmpe.c build when OF is not enabled mfd: jz4740-adc: Use devm_kzalloc ...

Merge tag 'for-v3.8-merged' of git://git.infradead.org/battery-2.6

2012-12-14T03:26:04Z

Pull battery subsystem updates from Anton Vorontsov: "Highlights: - Two new drivers from Pali Rohár and N900 hackers: rx51_battery and bq2415x_charger. The drivers are a part of a solution to replace the proprietary Nokia BME stack - Power supply core now registers devices with a thermal cooling subsystem, so we can now automatically throttle charging. Thanks to Ramakrishna Pallala! - Device tree support for ab8500 and max8925_power drivers - Random fixups and enhancements for a bunch of drivers." * tag 'for-v3.8-merged' of git://git.infradead.org/battery-2.6: (22 commits) max8925_power: Add support for device-tree initialization ab8500: Add devicetree support for chargalg ab8500: Add devicetree support for charger ab8500: Add devicetree support for btemp ab8500: Add devicetree support for fuelgauge twl4030_charger: Change TWL4030_MODULE_* ids to TWL_MODULE_* jz4740-battery: Use devm_request_and_ioremap jz4740-battery: Use devm_kzalloc bq27x00_battery: Fixup nominal available capacity reporting bq2415x_charger: Fix style issues bq2415x_charger: Add Kconfig/Makefile entries power_supply: Add bq2415x charger driver power_supply: Add new Nokia RX-51 (N900) power supply battery driver max17042_battery: Fix missing verify_model_lock() return value check ds2782_battery: Fix signedness bug in ds278x_read_reg16() lp8788-charger: Fix ADC channel names lp8788-charger: Fix wrong ADC conversion lp8788-charger: Use consumer device name on setting IIO channels power_supply: Register power supply for thermal cooling device power_supply: Add support for CHARGE_CONTROL_* attributes ...