linux/drivers/serial/sh-sci.c, branch v2.6.25

serial: fix platform driver hotplug/coldplug

2008-04-16T02:35:40Z

Since 43cc71eed1250755986da4c0f9898f9a635cb3bf, the platform modalias is prefixed with "platform:". Add MODULE_ALIAS() to the hotpluggable serial platform drivers, to re-enable auto loading. NOTE that Kconfig for some of these drivers doesn't allow modular builds, and thus doesn't match the driver source's unload support. Presumably their unload code is buggy and/or weakly tested... [dbrownell@users.sourceforge.net: more drivers, registration fixes] Signed-off-by: Kay Sievers Signed-off-by: David Brownell Acked-by: Peter Korsgaard Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

serial: sh-sci: Fix fifo stall on SH7760/SH7780/SH7785 SCIF.

2008-03-11T04:58:50Z

There was an off-by-1 in the SCRFDR calculation that caused writes over 128-bytes to hang in the FIFO. Fix it up. Signed-off-by: Yutaro Ebihara Signed-off-by: Paul Mundt

serial: Move asm-sh/sci.h to linux/serial_sci.h.

2008-02-26T05:52:45Z

This header is needed on other architectures as well (namely h8300), which currently fails to build without this in place. Rather than duplicating the port definition completely there, just move this to a common location instead. This should get h8300 working again for 2.6.25, in addition to the changes already pushed by Sato-san in -rc2. Signed-off-by: Paul Mundt

sh: add support for sh7366 processor

2008-02-14T05:22:10Z

This patch adds sh7366 cpu supports. Just the most basic things like interrupt controller, clocks and serial port are included at this point. Signed-off-by: Magnus Damm Signed-off-by: Paul Mundt

sh: Add support for SH7763 CPU subtype.

2008-01-28T04:19:02Z

Signed-off-by: Yoshihiro Shimoda Signed-off-by: Paul Mundt

sh: Add support for SH7721 CPU subtype.

2008-01-28T04:19:02Z

Signed-off-by: Yoshihiro Shimoda Signed-off-by: Paul Mundt

serial: sh-sci: kgdb console build fixes.

2007-09-21T02:57:53Z

The kgdb console code requires uart_set_options() and friends, which are only provided by the serial core when console support is enabled. These were sitting under CONFIG_SH_KGDB and resulted in a link error when console support wasn't enabled, work that by rolling the console routines under CONFIG_SH_KGDB_CONSOLE, which they should have been all along. Signed-off-by: Paul Mundt

sh: Add SH7720 CPU support.

2007-09-21T02:57:49Z

This adds support for the SH7720 (SH3-DSP) CPU. Signed-off by: Markus Brunner Signed-off by: Mark Jonas Signed-off-by: Paul Mundt

serial: sh-sci: Tidy cpufreq printk.

2007-09-21T02:57:49Z

This was a bit more verbose than it needed to be. Signed-off-by: Paul Mundt

sh: remove support for sh7300 and solution engine 7300

2007-07-26T06:37:57Z

This patch removes old dead code: - kill off sh7300 cpu support - get rid of broken solution engine 7300 board support Signed-off-by: Magnus Damm Signed-off-by: Paul Mundt