linux/drivers/serial/sh-sci.c, branch v2.6.26

sh: use the common ascii hex helpers

2008-05-16T06:09:08Z

Signed-off-by: Harvey Harrison Signed-off-by: Paul Mundt

sh-sci: improve sh7722 support

2008-05-08T10:51:57Z

Improve sh7722 support for SCIF1 and SCIF2 and separate code from sh7366 implementation. Signed-off-by: Magnus Damm Signed-off-by: Paul Mundt

sh: Enable use of the clk fwk on SH-5.

2008-05-08T10:51:42Z

Signed-off-by: Paul Mundt

serial: replace remaining FUNCTION occurrences

2008-04-30T15:29:54Z

__FUNCTION__ is gcc-specific, use __func__ Signed-off-by: Harvey Harrison Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

sh: Add support for SH7723 CPU subtype.

2008-04-18T16:50:07Z

This adds basic support for the SH7723 MobileR2 CPU. Signed-off-by: Paul Mundt

serial: fix platform driver hotplug/coldplug

2008-04-16T02:35:40Z

Since 43cc71eed1250755986da4c0f9898f9a635cb3bf, the platform modalias is prefixed with "platform:". Add MODULE_ALIAS() to the hotpluggable serial platform drivers, to re-enable auto loading. NOTE that Kconfig for some of these drivers doesn't allow modular builds, and thus doesn't match the driver source's unload support. Presumably their unload code is buggy and/or weakly tested... [dbrownell@users.sourceforge.net: more drivers, registration fixes] Signed-off-by: Kay Sievers Signed-off-by: David Brownell Acked-by: Peter Korsgaard Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

serial: sh-sci: Fix fifo stall on SH7760/SH7780/SH7785 SCIF.

2008-03-11T04:58:50Z

There was an off-by-1 in the SCRFDR calculation that caused writes over 128-bytes to hang in the FIFO. Fix it up. Signed-off-by: Yutaro Ebihara Signed-off-by: Paul Mundt

serial: Move asm-sh/sci.h to linux/serial_sci.h.

2008-02-26T05:52:45Z

This header is needed on other architectures as well (namely h8300), which currently fails to build without this in place. Rather than duplicating the port definition completely there, just move this to a common location instead. This should get h8300 working again for 2.6.25, in addition to the changes already pushed by Sato-san in -rc2. Signed-off-by: Paul Mundt

sh: add support for sh7366 processor

2008-02-14T05:22:10Z

This patch adds sh7366 cpu supports. Just the most basic things like interrupt controller, clocks and serial port are included at this point. Signed-off-by: Magnus Damm Signed-off-by: Paul Mundt

sh: Add support for SH7763 CPU subtype.

2008-01-28T04:19:02Z

Signed-off-by: Yoshihiro Shimoda Signed-off-by: Paul Mundt