linux/drivers/thunderbolt, branch v6.4

thunderbolt: Mask ring interrupt on Intel hardware as well

2023-05-31T07:37:21Z

When resuming from system sleep states the driver issues following warning on Intel hardware: thunderbolt 0000:07:00.0: interrupt for TX ring 0 is already enabled The reason for this is that the commit in question did not mask the ring interrupt on Intel hardware leaving the interrupt active. Fix this by masking it also in Intel hardware. Reported-by: beld zhang Tested-by: beld zhang Closes: https://lore.kernel.org/linux-usb/ZHKW5NeabmfhgLbY@debian.me/ Fixes: c4af8e3fecd0 ("thunderbolt: Clear registers properly when auto clear isn't in use") Cc: stable@vger.kernel.org Reviewed-by: Mario Limonciello Signed-off-by: Mika Westerberg

thunderbolt: Do not touch CL state configuration during discovery

2023-05-29T09:49:16Z

If the boot firmware has already established tunnels, especially ones that have special requirements from the link such as DisplayPort, we should not blindly enable CL states (nor change the TMU configuration). Otherwise the existing tunnels may not work as expected. For this reason, skip the CL state enabling when we go over the existing topology. This will also keep the TMU settings untouched because we do not change the TMU configuration when CL states are not enabled. Reported-by: Koba Ko Closes: https://gitlab.freedesktop.org/drm/intel/-/issues/7831 Cc: stable@vger.kernel.org # v6.0+ Acked-By: Yehezkel Bernat Signed-off-by: Mika Westerberg

thunderbolt: Increase DisplayPort Connection Manager handshake timeout

2023-05-29T09:49:00Z

It turns out that when plugging in VGA cable through USB-C to VGA/DVI dongle the Connection Manager handshake can take longer time, at least on Intel Titan Ridge based docks such as Dell WD91TB. This leads to following error in the dmesg: thunderbolt 0000:00:0d.3: 3:10: DP tunnel activation failed, aborting and the display stays blank (because we failed to establish the tunnel). For this reason increase the timeout to 3s. Reported-by: Koba Ko Cc: stable@vger.kernel.org Acked-By: Yehezkel Bernat Signed-off-by: Mika Westerberg

thunderbolt: dma_test: Use correct value for absent rings when creating paths

2023-05-22T05:57:50Z

Both tb_xdomain_enable_paths() and tb_xdomain_disable_paths() expect -1, not 0, if the corresponding ring is not needed. For this reason change the driver to use correct value for the rings that are not needed. Fixes: 180b0689425c ("thunderbolt: Allow multiple DMA tunnels over a single XDomain connection") Cc: stable@vger.kernel.org Reported-by: Pengfei Xu Tested-by: Pengfei Xu Signed-off-by: Mika Westerberg

thunderbolt: Clear registers properly when auto clear isn't in use

2023-05-09T06:39:03Z

When `QUIRK_AUTO_CLEAR_INT` isn't set, interrupt masking should be cleared by writing to Interrupt Mask Clear (IMR) and interrupt status should be cleared properly at shutdown/init. This fixes an error where interrupts are left enabled during resume from hibernation with `CONFIG_USB4=y`. Fixes: 468c49f44759 ("thunderbolt: Disable interrupt auto clear for rings") Cc: stable@vger.kernel.org # v6.3 Reported-by: Takashi Iwai Link: https://bugzilla.kernel.org/show_bug.cgi?id=217343 Signed-off-by: Mario Limonciello Signed-off-by: Mika Westerberg

Merge tag 'thunderbolt-for-v6.4-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/westeri/thunderbolt into usb-next

2023-04-19T09:42:44Z

Mika writes: thunderbolt: Changes for v6.4 merge window This includes following Thunderbolt/USB4 changes for the v6.4 merge window: - Refactoring of DROM read code paths - Convert to use SI units from units.h - A couple of cleanups All these have been in linux-next with no reported issues. * tag 'thunderbolt-for-v6.4-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/westeri/thunderbolt: thunderbolt: Introduce usb4_port_sb_opcode_err_to_errno() helper thunderbolt: Make use of SI units from units.h thunderbolt: Get rid of redundant 'else' thunderbolt: Refactor DROM reading thunderbolt: use `tb_eeprom_get_drom_offset` to discover DROM offset

thunderbolt: Introduce usb4_port_sb_opcode_err_to_errno() helper

2023-04-03T05:37:18Z

The usb4_port_sb_opcode_err_to_errno() converts from USB4 error codes to the Linux errno space. In particular, this makes the intention of the repeating usb4_port_retimer_read() call in the usb4_port_retimer_nvm_authenticate_status() clearer. Signed-off-by: Andy Shevchenko Signed-off-by: Mika Westerberg

thunderbolt: Make use of SI units from units.h

2023-03-29T08:05:05Z

In a couple of places it seems reasonable to use MEGA intead of explicit number. It makes code more readable and robust. Signed-off-by: Andy Shevchenko Signed-off-by: Mika Westerberg

thunderbolt: Get rid of redundant 'else'

2023-03-29T08:05:05Z

In the snippets like the following if (...) return / goto / break / continue ...; else ... the 'else' is redundant. Get rid of it. Signed-off-by: Andy Shevchenko Signed-off-by: Mika Westerberg

thunderbolt: Rename shadowed variables bit to interrupt_bit and auto_clear_bit

2023-03-20T17:00:58Z

cppcheck reports drivers/thunderbolt/nhi.c:74:7: style: Local variable 'bit' shadows outer variable [shadowVariable] int bit; ^ drivers/thunderbolt/nhi.c:66:6: note: Shadowed declaration int bit = ring_interrupt_index(ring) & 31; ^ drivers/thunderbolt/nhi.c:74:7: note: Shadow variable int bit; ^ For readablity rename the outer to interrupt_bit and the innner to auto_clear_bit. Fixes: 468c49f44759 ("thunderbolt: Disable interrupt auto clear for ring") Cc: stable@vger.kernel.org Signed-off-by: Tom Rix Signed-off-by: Mika Westerberg