linux/drivers/usb/host, branch v4.9

drivers/usb: Skip auto handoff for TI and RENESAS usb controllers

2016-11-07T09:12:22Z

Never seen XHCI auto handoff working on TI and RENESAS cards. Eventually, we force handoff. This code forces the handoff unconditionally. It saves 5 seconds boot time for each card. Signed-off-by: Babu Moger Signed-off-by: Greg Kroah-Hartman

usb: increase ohci watchdog delay to 275 msec

2016-10-24T12:30:32Z

Increase ohci watchout delay to 275 ms. Previous delay was 250 ms with 20 ms of slack, after removing slack time some ohci controllers don't respond in time. Logs from systems with controllers that have the issue would show "HcDoneHead not written back; disabled" Signed-off-by: Bryan Paluch Acked-by: Alan Stern Cc: stable Signed-off-by: Greg Kroah-Hartman

usb: ehci-platform: increase EHCI_MAX_RSTS to 4

2016-10-24T12:29:08Z

Socionext LD11 SoC (arch/arm64/boot/dts/socionext/uniphier-ld11.dtsi) needs to handle 4 reset lines for EHCI. Signed-off-by: Masahiro Yamada Signed-off-by: Greg Kroah-Hartman

usb: ohci-at91: Set RemoteWakeupConnected bit explicitly.

2016-10-24T12:29:08Z

The reset value of RWC is 0, set RemoteWakeupConnected bit explicitly before calling ohci_run, it also fixes the issue that the mass storage stick connected wasn't suspended when the system suspend. Signed-off-by: Wenyou Yang Signed-off-by: Greg Kroah-Hartman

xhci: use default USB_RESUME_TIMEOUT when resuming ports.

2016-10-20T15:54:55Z

USB2 host inititated resume, and system suspend bus resume need to use the same USB_RESUME_TIMEOUT as elsewhere. This resolves a device disconnect issue at system resume seen on Intel Braswell and Apollolake, but is in no way limited to those platforms. Signed-off-by: Mathias Nyman CC: Signed-off-by: Greg Kroah-Hartman

xhci: workaround for hosts missing CAS bit

2016-10-20T15:54:55Z

If a device is unplugged and replugged during Sx system suspend some Intel xHC hosts will overwrite the CAS (Cold attach status) flag and no device connection is noticed in resume. A device in this state can be identified in resume if its link state is in polling or compliance mode, and the current connect status is 0. A device in this state needs to be warm reset. Intel 100/c230 series PCH specification update Doc #332692-006 Errata #8 Observed on Cherryview and Apollolake as they go into compliance mode if LFPS times out during polling, and re-plugged devices are not discovered at resume. Signed-off-by: Mathias Nyman CC: Signed-off-by: Greg Kroah-Hartman

xhci: add restart quirk for Intel Wildcatpoint PCH

2016-10-20T15:54:55Z

xHC in Wildcatpoint-LP PCH is similar to LynxPoint-LP and need the same quirks to prevent machines from spurious restart while shutting them down. Reported-by: Hasan Mahmood CC: Signed-off-by: Mathias Nyman Signed-off-by: Greg Kroah-Hartman

Merge branch 'upstream' of git://git.linux-mips.org/pub/scm/ralf/upstream-linus

2016-10-15T16:26:12Z

Pull MIPS updates from Ralf Baechle: "This is the main MIPS pull request for 4.9: MIPS core arch code: - traps: 64bit kernels should read CP0_EBase 64bit - traps: Convert ebase to KSEG0 - c-r4k: Drop bc_wback_inv() from icache flush - c-r4k: Split user/kernel flush_icache_range() - cacheflush: Use __flush_icache_user_range() - uprobes: Flush icache via kernel address - KVM: Use __local_flush_icache_user_range() - c-r4k: Fix flush_icache_range() for EVA - Fix -mabi=64 build of vdso.lds - VDSO: Drop duplicated -I*/-E* aflags - tracing: move insn_has_delay_slot to a shared header - tracing: disable uprobe/kprobe on compact branch instructions - ptrace: Fix regs_return_value for kernel context - Squash lines for simple wrapper functions - Move identification of VP(E) into proc.c from smp-mt.c - Add definitions of SYNC barrierstype values - traps: Ensure full EBase is written - tlb-r4k: If there are wired entries, don't use TLBINVF - Sanitise coherentio semantics - dma-default: Don't check hw_coherentio if device is non-coherent - Support per-device DMA coherence - Adjust MIPS64 CAC_BASE to reflect Config.K0 - Support generating Flattened Image Trees (.itb) - generic: Introduce generic DT-based board support - generic: Convert SEAD-3 to a generic board - Enable hardened usercopy - Don't specify STACKPROTECTOR in defconfigs Octeon: - Delete dead code and files across the platform. - Change to use all memory into use by default. - Rename upper case variables in setup code to lowercase. - Delete legacy hack for broken bootloaders. - Leave maintaining the link state to the actual ethernet/PHY drivers. - Add DTS for D-Link DSR-500N. - Fix PCI interrupt routing on D-Link DSR-500N. Pistachio: - Remove ANDROID_TIMED_OUTPUT from defconfig TX39xx: - Move GPIO setup from .mem_setup() to .arch_init() - Convert to Common Clock Framework TX49xx: - Move GPIO setup from .mem_setup() to .arch_init() - Convert to Common Clock Framework txx9wdt: - Add missing clock (un)prepare calls for CCF BMIPS: - Add PW, GPIO SDHCI and NAND device node names - Support APPENDED_DTB - Add missing bcm97435svmb to DT_NONE - Rename bcm96358nb4ser to bcm6358-neufbox4-sercom - Add DT examples for BCM63268, BCM3368 and BCM6362 - Add support for BCM3368 and BCM6362 PCI - Reduce stack frame usage - Use struct list_head lists - Support for CONFIG_PCI_DOMAINS_GENERIC - Make pcibios_set_cache_line_size an initcall - Inline pcibios_assign_all_busses - Split pci.c into pci.c & pci-legacy.c - Introduce CONFIG_PCI_DRIVERS_LEGACY - Support generic drivers CPC - Convert bare 'unsigned' to 'unsigned int' - Avoid lock when MIPS CM >= 3 is present GIC: - Delete unused file smp-gic.c mt7620: - Delete unnecessary assignment for the field "owner" from PCI BCM63xx: - Let clk_disable() return immediately if clk is NULL pm-cps: - Change FSB workaround to CPU blacklist - Update comments on barrier instructions - Use MIPS standard lightweight ordering barrier - Use MIPS standard completion barrier - Remove selection of sync types - Add MIPSr6 CPU support - Support CM3 changes to Coherence Enable Register SMP: - Wrap call to mips_cpc_lock_other in mips_cm_lock_other - Introduce mechanism for freeing and allocating IPIs cpuidle: - cpuidle-cps: Enable use with MIPSr6 CPUs. SEAD3: - Rewrite to use DT and generic kernel feature. USB: - host: ehci-sead3: Remove SEAD-3 EHCI code FBDEV: - cobalt_lcdfb: Drop SEAD3 support dt-bindings: - Document a binding for simple ASCII LCDs auxdisplay: - img-ascii-lcd: driver for simple ASCII LCD displays irqchip i8259: - i8259: Add domain before mapping parent irq - i8259: Allow platforms to override poll function - i8259: Remove unused i8259A_irq_pending Malta: - Rewrite to use DT of/platform: - Probe "isa" busses by default CM: - Print CM error reports upon bus errors Module: - Migrate exception table users off module.h and onto extable.h - Make various drivers explicitly non-modular: - Audit and remove any unnecessary uses of module.h mailmap: - Canonicalize to Qais' current email address. Documentation: - MIPS supports HAVE_REGS_AND_STACK_ACCESS_API Loongson1C: - Add CPU support for Loongson1C - Add board support - Add defconfig - Add RTC support for Loongson1C board All this except one Documentation fix has sat in linux-next and has survived Imagination's automated build test system" * 'upstream' of git://git.linux-mips.org/pub/scm/ralf/upstream-linus: (127 commits) Documentation: MIPS supports HAVE_REGS_AND_STACK_ACCESS_API MIPS: ptrace: Fix regs_return_value for kernel context MIPS: VDSO: Drop duplicated -I*/-E* aflags MIPS: Fix -mabi=64 build of vdso.lds MIPS: Enable hardened usercopy MIPS: generic: Convert SEAD-3 to a generic board MIPS: generic: Introduce generic DT-based board support MIPS: Support generating Flattened Image Trees (.itb) MIPS: Adjust MIPS64 CAC_BASE to reflect Config.K0 MIPS: Print CM error reports upon bus errors MIPS: Support per-device DMA coherence MIPS: dma-default: Don't check hw_coherentio if device is non-coherent MIPS: Sanitise coherentio semantics MIPS: PCI: Support generic drivers MIPS: PCI: Introduce CONFIG_PCI_DRIVERS_LEGACY MIPS: PCI: Split pci.c into pci.c & pci-legacy.c MIPS: PCI: Inline pcibios_assign_all_busses MIPS: PCI: Make pcibios_set_cache_line_size an initcall MIPS: PCI: Support for CONFIG_PCI_DOMAINS_GENERIC MIPS: PCI: Use struct list_head lists ...

treewide: remove redundant #include

2016-10-11T22:06:33Z

Kernel source files need not include explicitly because the top Makefile forces to include it with: -include $(srctree)/include/linux/kconfig.h This commit removes explicit includes except the following: * arch/s390/include/asm/facilities_src.h * tools/testing/radix-tree/linux/kernel.h These two are used for host programs. Link: http://lkml.kernel.org/r/1473656164-11929-1-git-send-email-yamada.masahiro@socionext.com Signed-off-by: Masahiro Yamada Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

USB: host: ehci-sead3: Remove SEAD-3 EHCI code

2016-10-04T23:31:20Z

The SEAD-3 board is now probing its EHCI controller using the generic EHCI driver & its generic-ehci device tree binding. Remove the unused SEAD-3 specific EHCI code. Signed-off-by: Paul Burton Acked-by: Alan Stern Cc: Greg Kroah-Hartman Cc: linux-mips@linux-mips.org Cc: linux-kernel@vger.kernel.org Cc: linux-usb@vger.kernel.org Patchwork: https://patchwork.linux-mips.org/patch/14052/ Signed-off-by: Ralf Baechle