linux/drivers/usb, branch v3.8

USB: storage: optimize to match the Huawei USB storage devices and support new switch command

2013-02-04T18:41:40Z

1. Optimize the match rules with new macro for Huawei USB storage devices, to avoid to load USB storage driver for the modem interface with Huawei devices. 2. Add to support new switch command for new Huawei USB dongles. Signed-off-by: fangxiaozhi Cc: stable Signed-off-by: Greg Kroah-Hartman

USB: storage: Define a new macro for USB storage match rules

2013-02-04T18:40:16Z

1. Define a new macro for USB storage match rules: matching with Vendor ID and interface descriptors. Signed-off-by: fangxiaozhi Cc: stable Signed-off-by: Greg Kroah-Hartman

USB: ftdi_sio: add Zolix FTDI PID

2013-02-02T12:31:52Z

Add support for Zolix Omni 1509 monochromator custom USB-RS232 converter. Signed-off-by: Petr Kubánek Cc: stable Signed-off-by: Greg Kroah-Hartman

USB: option: add Changhong CH690

2013-02-02T12:31:50Z

New device with 3 serial interfaces: If#= 0 Alt= 0 #EPs= 3 Cls=ff(vend) Sub=ff Prot=ff If#= 1 Alt= 0 #EPs= 2 Cls=ff(vend) Sub=ff Prot=ff If#= 2 Alt= 0 #EPs= 2 Cls=ff(vend) Sub=ff Prot=ff If#= 3 Alt= 0 #EPs= 2 Cls=08(stor) Sub=06 Prot=50 Cc: Signed-off-by: Bjørn Mork Signed-off-by: Greg Kroah-Hartman

USB: ftdi_sio: add PID/VID entries for ELV WS 300 PC II

2013-02-02T12:28:42Z

Add PID/VID entries for ELV WS 300 PC II weather station Signed-off-by: Sven Killig Cc: stable Signed-off-by: Greg Kroah-Hartman

USB: add OWL CM-160 support to cp210x driver

2013-01-31T12:51:12Z

This adds support for the OWL CM-160 electricity monitor to the cp210x driver. Signed-off-by: Luis Llorente Signed-off-by: Greg Kroah-Hartman

USB: EHCI: fix bug in scheduling periodic split transfers

2013-01-31T09:14:48Z

This patch (as1654) fixes a very old bug in ehci-hcd, connected with scheduling of periodic split transfers. The calculations for full/low-speed bus usage are all carried out after the correction for bit-stuffing has been applied, but the values in the max_tt_usecs array assume it hasn't been. The array should allow for allocation of up to 90% of the bus capacity, which is 900 us, not 780 us. The symptom caused by this bug is that any isochronous transfer to a full-speed device with a maxpacket size larger than about 980 bytes is always rejected with a -ENOSPC error. Signed-off-by: Alan Stern Cc: stable Signed-off-by: Greg Kroah-Hartman

USB: EHCI: fix for leaking isochronous data

2013-01-31T09:14:48Z

This patch (as1653) fixes a bug in ehci-hcd. Unlike iTD entries, an siTD entry in the periodic schedule may not complete until the frame after the one it belongs to. Consequently, when scanning the periodic schedule it is necessary to start with the frame _preceding_ the one where the previous scan ended. Not doing this properly can result in memory leaks and failures to complete isochronous URBs. Signed-off-by: Alan Stern Reported-by: Andy Leiserson Cc: stable Signed-off-by: Greg Kroah-Hartman

USB: option: add support for Telit LE920

2013-01-30T05:19:20Z

Add PID and special handling for Telit LE920 Signed-off-by: Daniele Palmas Cc: stable Signed-off-by: Greg Kroah-Hartman

USB: qcserial: add Telit Gobi QDL device

2013-01-30T05:19:20Z

Add VID and PID for Telit Gobi QDL device Signed-off-by: Daniele Palmas Cc: stable Signed-off-by: Greg Kroah-Hartman