linux/include/video, branch v2.6.26

fbdev: platforming hecubafb and n411

2008-04-28T15:58:41Z

This patch splits hecubafb into the platform independent hecubafb and the platform dependent n411. Signed-off-by: Jaya Kumar Cc: "Antonino A. Daplas" Cc: Geert Uytterhoeven Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

fbdev: platforming metronomefb and am200epd

2008-04-28T15:58:41Z

This patch splits metronomefb into the platform independent metronomefb and the platform dependent am200epd. Signed-off-by: Jaya Kumar Cc: "Antonino A. Daplas" Cc: Geert Uytterhoeven Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

atmel_lcdfb: wiring BGR to RGB color mode

2008-04-28T15:58:39Z

Adds different wiring mode for the LCD screen. The legacy atmel LCDC IP uses a non standard color mode, "BGR-555.1" instead "RGB-565". The major part of graphic stacks for embedded systems uses only "RGB-565". It is possible to swap LCD IOs instead of doing this bit swapping by software (See application note AT91SAM9 LCD Controller http://www.atmel.com/dyn/resources/prod_documents/doc6300.pdf) This wire swapping is done on the at91sam9rl-ek board (board code using this patch will come later). Signed-off-by: Nicolas Ferre Cc: David Brownell Cc: Hans-Christian Egtvedt Cc: Haavard Skinnemoen Cc: Andrew Victor Cc: "Antonino A. Daplas" Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

atmel_lcdfb: suspend/resume support

2008-04-28T15:58:38Z

Teach atmel_lcdfb driver how to suspend/resume. Note that the backlight control should probably do more of the same stuff: turning off display power (more than just the backlight) and stopping the clocks (and dma to drive the no-longer-seen display). No point in wasting power to generate images that can't be observed, after all... Signed-off-by: David Brownell Signed-off-by: Nicolas Ferre Cc: Hans-Christian Egtvedt Cc: Haavard Skinnemoen Cc: Andrew Victor Cc: "Antonino A. Daplas" Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

atmel_lcdfb: backlight control

2008-02-06T18:41:16Z

On the sam9 EK boards, the LCD backlight is hooked up to a PWM output from the LCD controller. It's controlled by "contrast" registers though. This patch lets boards declare that they have that kind of backlight control. The driver can then export this control, letting screenblank and other operations actually take effect ... reducing the typically substantial power drain from the backlight. Note that it's not fully cooked - doesn't force backlight off during system suspend - the "power" and "blank" events may not be done right This should be easily added in the future. [nicolas.ferre@atmel.com: remove unneeded inline and rename functions] Signed-off-by: David Brownell Signed-off-by: Nicolas Ferre Cc: Andrew Victor Cc: Russell King Cc: "Antonino A. Daplas" Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

atmel_lcdfb: validate display timings

2008-02-06T18:41:15Z

Setting a display timing parameter too high or too low may cause it to wrap around and thus become completely wrong. Validate the timings in atmel_lcdfb_check_var() and saturate to the highest or lowest possible value if necessary. Signed-off-by: Haavard Skinnemoen Cc: "Antonino A. Daplas" Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

Make asm-x86/bootparam.h includable from userspace.

2007-10-23T05:49:47Z

To actually write a bootloader (or, say, the lguest launcher) currently requires duplication of these structures. Making them includable from userspace is much nicer. We merge the common userspace-required definitions of e820_32/64.h into e820.h for export. Signed-off-by: Rusty Russell

define global BIT macro

2007-10-19T18:53:42Z

define global BIT macro move all local BIT defines to the new globally define macro. Signed-off-by: Jiri Slaby Cc: Paul Mackerras Cc: Benjamin Herrenschmidt Cc: Kumar Gala Cc: Dmitry Torokhov Cc: Jeff Garzik Cc: James Bottomley Cc: "Antonino A. Daplas" Cc: Russell King Acked-by: Ralf Baechle Cc: "John W. Linville" Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

pm2fb: hardware cursor support for the Permedia2

2007-10-16T16:43:18Z

This patch adds hardware cursor support for the Permedia 2 chip. Signed-off-by: Krzysztof Helt Signed-off-by: Antonino Daplas Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds

pm3fb: header file cleanup

2007-10-16T16:43:18Z

This patch fixes white spaces, redudant definitions and formating in the pm3fb header file. Signed-off-by: Krzysztof Helt Signed-off-by: Antonino Daplas Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds